Home › Engine / Hybrid System ยท 6AR-FSE › ENGINE CONTROL › HEATED OXYGEN SENSOR

HEATED OXYGEN SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL HEATED OXYGEN SENSOR


    A335626E02
  1. Using SST, install the heated oxygen sensor to the front exhaust pipe assembly.
    Text in Illustration 
    *a
    Torque Wrench Fulcrum Length

    SST
    09224-00011  

    Torque:
    Specified tightening torque:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }

    NOTICE:
    If the heated oxygen sensor has been struck or dropped, replace it.

    HINT:
    1. Calculate the torque wrench reading when changing the fulcrum length of the torque wrench (Click here).
    2. When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 260 mm (10.2 in.)): 39 N*m (398 kgf*cm, 29 ft.*lbf)

  1. Connect the heated oxygen sensor connector.



2. INSPECT FOR EXHAUST GAS LEAK
If gas is leaking, tighten the areas necessary to stop the leak. Replace damaged parts as necessary.
  1. Perform Inspection After Repair after repairing an exhaust gas leak (Click here).