Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM

TELEMATICS SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use the following procedure to troubleshoot the telematics system.
  2. *: Use the GTS.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CHECK PROBLEM SYMPTOM
    1. The telematics system provides a variety of functions. Therefore, it is important to identify whether a malfunction is related to the communication system, including radio wave signal conditions, or any other systems. Carefully confirm the conditions that caused the malfunction in order to determine if a temporary problem with the radio wave signal conditions caused the malfunction.

      Displayed Message and Problem Symptom
      Cause
      A message is temporarily displayed indicating to try again after waiting for a while because the lines are busy.
      This is caused when there is a problem with the radio wave signal conditions or when the base station is busy. This is not a malfunction (inform the customer that this is not a malfunction and ask them to use the system as is).


    NEXT


    3.INSPECT BATTERY VOLTAGE
    1. Measure the battery voltage.

      Standard Voltage:
      11 to 14 V

      HINT:
      If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.


    NEXT


    4.CHECK CAN COMMUNICATION SYSTEM*
    1. Use the GTS to check if the CAN communication system is functioning normally (Click here).

      Result:
      Result
      Proceed to
      CAN communication system DTCs are not output
      A
      CAN communication system DTCs are output
      B



    B.
    GO TO CAN COMMUNICATION SYSTEM (Click here)
    A


    5.CHECK FOR DTC*
    1. Refer to DTC Check/Clear (Click here).

      Result:
      Result
      Proceed to
      DTCs are output
      A
      DTCs are not output
      B



    B.
    Go to step 9
    A


    6.DTC CLEAR*
    1. Refer to DTC Check/Clear (Click here).

      HINT:
      The present DTCs may not indicate actual malfunctions depending on the vehicle operating conditions.


    NEXT


    7.RECHECK FOR DTC*
    1. Refer to DTC Check/Clear (Click here).

      Result:
      Result
      Proceed to
      DTCs are output
      A
      DTCs are not output
      B

    2. HINT:
      1. Even if the malfunction symptom is not confirmed, check for DTCs. This is because the system stores history DTCs.
      2. Check the DTCs and inspect the area that the code indicates.



    B.
    Go to step 9
    A


    8.DIAGNOSTIC TROUBLE CODE CHART
    1. Find the output code in Diagnostic Trouble Code Chart (Click here).


    NEXT

    Go to step 11


    9.PROBLEM SYMPTOMS TABLE
    1. Refer to Problem Symptoms Table (Click here).

      Result:
      Result
      Proceed to
      Fault is not listed in Problem Symptoms Table
      A
      Fault is listed in Problem Symptoms Table
      B

      HINT:
      If the symptom does not recur and no DTCs are output, perform the simulation method (Click here).



    B.
    Go to step 11
    A


    10.PERFORM TROUBLESHOOTING BASED ON MALFUNCTION SYMPTOM
    1. Refer to Terminals of ECU (Click here).


    NEXT


    11.CHECK CIRCUIT
    1. Adjust, repair or replace as necessary.

      NOTICE:
      Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Registration for Telematics System (Click here).


    NEXT


    12.PERFORM CONFIRMATION TEST

      NEXT

      END