Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM

TELEMATICS SYSTEM > TERMINALS OF ECU

for Preparation Click here



TELEMATICS TRANSCEIVER

HINT:
check from the rear of the connector while it is connected to the components.


E342820E01


Text in Illustration 
*A
w/ Navigation System
*B
w/o Navigation System
*a
Connector Color: Blue (to Telephone Antenna)
*b
Connector Color: Gray (to GPS Antenna)

Terminal No. (Symbol)
Wiring Color
Terminal Description
Condition
Specified Condition
I218-1 (+B) - I218-4 (E)
V - BR
Power source (+B)
Always
11 to 14 V
I218-2 (SPI+) - I218-4 (E)
Y*1L*2 - BR
Sound signal
Audio system playing
A waveform synchronized with sounds is output
I218-3 (SPI-) - I218-4 (E)
P - BR
Sound signal
Audio system playing
A waveform synchronized with sounds is output
I218-4 (E) - Body ground
BR - Body ground
Ground
Always
Below 1 V
I218-5 (SPO+) - I218-4 (E)
P - BR
Sound signal
Audio system playing, or emergency call mode
A waveform synchronized with sound signals is output
I218-6 (SPO-) - I218-4 (E)
V - BR
Sound signal
Audio system playing, or emergency call mode
A waveform synchronized with sound signals is output
I218-7 (IG2) - I218-4 (E)
R - BR
Power source (IG)
Ignition switch ON
11 to 14 V
Ignition switch off
Below 1 V
I218-8 (ACC) - I218-4 (E)
GR - BR
Power source (ACC)
Ignition switch ACC
11 to 14 V
Ignition switch off
Below 1 V
I218-9 (SLED) - I218-4 (E)
P - BR
Manual (SOS) switch illumination power supply
Ignition switch ACC
11 to 14 V
Ignition switch off
Below 1 V
I218-10 (SPDP) - I218-4 (E)
V - BR
Vehicle speed signal
See "Vehicle Signal Check Mode" in Operation Check (Click here)
-
I218-11 (IND1) - I218-4 (E)
G - BR
Manual (SOS) switch indicator (red) illumination signal
For 10 seconds after ignition switch is turned to ON
1 to 8.5 V
Ignition switch off
Below 1 V
I218-12 (IND2) - I218-4 (E)
GR - BR
Manual (SOS) switch indicator (green) illumination signal
For 2 seconds after ignition switch is turned to ON
1 to 8.5 V
Ignition switch off
Below 1 V
I218-15 (CANP)
SB
CAN communication signal
-
-
I218-16 (CANN)
W
CAN communication signal
-
-
I218-17 (MUTE) - I218-4 (E)
R*1LG*2 - BR
Mute Signal
Audio system playing
5.0 V or less
Emergency call mode
Below 1 V
I218-18 (MCO+) - I218-4 (E)
R - BR
Microphone voice signal
See "Microphone Check" in Operation Check (Click here)
-
I218-19 (MCO-) - I218-4 (E)
G - BR
Microphone voice signal
See "Microphone Check" in Operation Check" (Click here)
-
I218-23 (ILL+) - I218-4 (E)
G - BR
Illumination signal
Light control switch off
Below 1 V
Light control switch in tail or head position
6.8 V or higher
I218-24 (GSW) - I218-4 (E)
W - BR
Collision detection signal
Engine switch on (IG)
Pulse generation
(Refer to waveform 1)
I218-26 (SIG-) - I218-4 (E)
Y - BR
Ground
Always
Below 1 V
I218-27 (SIG1) - I218-4 (E)
L - BR
Manual (SOS) switch condition signal
Manual (SOS) switch not pressed
2.0 to 2.3 V
Manual (SOS) switch pressed
Below 1 V
I218-32 (SGND) - I218-4 (E)
Shield - BR
Shield ground
Always
Below 1 V
I218-33 (MCVD) - I218-4 (E)
B - BR
Microphone power supply
Ignition switch off
Below 1 V
Ignition switch ACC
4 to 6 V
I218-34 (MCI+) - I218-4 (E)
W - BR
Receive microphone voice signal
See "Microphone Check" in Operation Check (Click here)
-
I218-35 (MCI-) - I218-4 (E)
R - BR
Receive microphone voice signal
See "Microphone Check" in Operation Check (Click here)
-
  1. *1: for 10 Speakers
  2. *2: for 6 Speakers


  1. Oscilloscope waveform:



      E165239E01
    1. Waveform 1
      Item
      Condition
      Tester Connection
      I218-24 (GSW) - I218-4 (E)
      Tool setting
      5.0 V/DIV., 20 ms/DIV..
      Vehicle condition
      Ignition switch ON


RADIO AND DISPLAY RECEIVER ASSEMBLY (for Radio and Disp;ay Type with Navigation System) (Click here)

RADIO AND DISPLAY RECEIVER ASSEMBLY (for Radio and Display Type without Navigation System) (Click here)

RADIO RECEIVER ASSEMBLY (for Radio Receiver Type) (Click here)