Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM

DTC    B15CC    Backup Battery Failure

for Preparation Click here


DESCRIPTION

This DTC is stored when the telematics transceiver detects one of the following:
  1. The mobilephone battery voltage drops or the mobilephone battery malfunctions.
  2. The mobilephone battery temperature is (temporarily) high.

DTC No.
DTC Detection Condition
Trouble Area
B15CC
Mobilephone battery malfunction is detected
  1. Telematics transceiver
  2. Mobilephone battery

INSPECTION PROCEDURE

NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Registration for Telematics System (Click here).

1.CHECK DTC
  1. Turn the ignition switch off.

  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch ON and wait for 20 seconds.

  1. Turn the GTS on.

  1. Check for DTCs and check that no DTCs are output (Click here).

    OK:
    No DTCs are output.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)  

2.REPLACE MOBILEPHONE BATTERY
  1. Replace the mobilephone battery with a new or known good one (Click here).

  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check that no DTCs are output.

    OK:
    No DTCs are output.



NG
Go to step 3
OK

END 

3.REPLACE TELEMATICS TRANSCEIVER
  1. Replace the telematics transceiver with a new one (Click here).


NEXT

PERFORM REGISTRATION (Click here)