Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM

DTC    B15F0    VIN Not Programmed or Mismatch - DCM

for Preparation Click here


DESCRIPTION

This DTC is stored when the Vehicle Identification Number (VIN) is not stored in the telematics transceiver or when the VIN stored in the telematics transceiver and the VIN stored in the ECM do not match.

DTC No.
DTC Detection Condition
Trouble Area
B15F0
When either of the following conditions is met:
  1. The VIN is not stored in the telematics transceiver.
  2. The VIN stored in the telematics transceiver and the VIN stored in the ECM do not match.
  1. SFI system
  2. CAN communication system.

INSPECTION PROCEDURE

1.REGISTER VEHICLE INFORMATION
  1. Turn the ignition switch off.

  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON and wait for 20 seconds.

  1. Turn the GTS on.

  1. Enter the following menus: Body Electrical / Telematics / Utility / Vin Synchronization

  1. According to the display on the GTS, perform VIN Synchronization to register the VIN to the telematics transceiver.


NEXT


2.CHECK DTC
  1. Turn the ignition switch off.

  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON and wait for 20 seconds.

  1. Turn the GTS on.

  1. Check for DTCs and check that no DTCs are output (Click here).

    OK:
    No DTCs are output.



NG
Go to step 3
OK

END 

3.CHECK CAN COMMUNICATION
  1. Check for DTCs and check that no DTCs are output (Click here).

    OK:
    CAN communication system DTCs are not output.

    Result:
    Result
    Proceed to
    NG
    A
    OK (for 2AR-FE)
    B
    OK (for 2GR-FE)
    C
    OK (for 6AR-FSE)
    D



B
GO TO SFI SYSTEM (for 2AR-FE) (Click here)

C
GO TO SFI SYSTEM (for 2GR-FE) (Click here)

D
GO TO SFI SYSTEM (for 6AR-FSE) (Click here)
A

GO TO CAN COMMUNICATION SYSTEM (Click here)