Home › Engine / Hybrid System › 2AR-FE (ENGINE CONTROL) › THROTTLE BODY › 2017.09–2021.02
RM33A0E _51 Engine / Hybrid System _065323 2AR-FE ENGINE CONTROL _0319007 THROTTLE BODY A

2AR-FE ENGINE CONTROL  THROTTLE BODY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed, or replaced during the throttle body with motor assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function when Necessary Procedure not Performed Link
·

Replacement of throttle body with motor assembly

·

Cleaning the deposits from the throttle body with motor assembly


Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

PROCEDURE

Hide 1.DRAIN ENGINE COOLANT

Hide 12601B 2.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 17705 3.REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE

a.
A405003

Disconnect the mass air flow meter sub-assembly connector.


b.

Disengage the 2 wire harness clamps.


c.
A405004C01
1.344,3.24 1.542,3.427 0.198,0.188 10 true *a 1.823,0.646 2.042,0.844 0.219,0.198 10 true *b 2.427,0.99 2.646,1.188 0.219,0.198 10 true *b 2.438,3 2.635,3.188 0.198,0.188 10 true *a
*a Air Cleaner Cap Clamp
*b Guide


Disengage the 2 air cleaner cap clamps.


d.

Disengage the 2 guides to separate the air cleaner cap sub-assembly from the air cleaner case sub-assembly.


e.
A405005

Slide the clip and disconnect the ventilation hose from the cylinder head cover sub-assembly.


f.
A405007

Disengage the 2 clamps to separate the No. 2 fuel vapor feed hose assembly.


g.
A405008

Loosen the hose clamp and remove the air cleaner cap with air cleaner hose from the throttle body with motor assembly.


Hide 22030 4.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY

a.
A405010

Disengage the 2 clamps to separate the heater hose.


b.
A405011

Disengage the clamp to disconnect the fuel tube sub-assembly from the fuel hose bracket.


c.

Remove the bolt and fuel hose bracket from the throttle body with motor assembly.


d.
A405012C01
0.958,1.125 1.156,1.333 0.198,0.208 10 true *1 1.781,1.969 2.021,2.167 0.24,0.198 10 true *2
*1 No. 1 Water By-pass Hose
*2 No. 2 Water By-pass Hose


Slide the 2 clips and disconnect the No. 1 water by-pass hose and No. 2 water by-pass hose from the throttle body with motor assembly.


e.

Disconnect the throttle body with motor assembly connector.


f.
A405014

Remove the 4 bolts and throttle body with motor assembly from the intake manifold.

NOTICE:

If the throttle body with motor assembly has been struck or dropped, replace it.



Hide 22271 5.REMOVE THROTTLE BODY GASKET

a.
A405015

Remove the throttle body gasket from the intake manifold.