Home › Engine / Hybrid System › 2AR-FE (ENGINE CONTROL) › MASS AIR FLOW METER › 2017.09–2021.02
RM33A0E _51 Engine / Hybrid System _065323 2AR-FE ENGINE CONTROL _0319009 MASS AIR FLOW METER G

2AR-FE ENGINE CONTROL  MASS AIR FLOW METER  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 22204 1.INSPECT MASS AIR FLOW METER SUB-ASSEMBLY

HINT:

Perform "Inspection After Repair" after replacing the mass air flow meter sub-assembly.

Click hereEngine / Hybrid System>2AR-FE (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION


a.

Read the value using the GTS (MAF).

NOTICE:
·

Perform the inspection with the vehicle indoors and on a level surface.

·

Perform the inspection of the mass air flow meter sub-assembly while it is installed to the air cleaner cap sub-assembly (installed to the vehicle).

·

During the test, do not use an exhaust air duct on the exhaust pipe.



i.

Connect the GTS to the DLC3.


ii.

Turn the ignition switch to ON (do not start the engine).


iii.

Turn the GTS on.


iv.

Enter the following menus: Powertrain / Engine and ECT / Data List / MAF.

Powertrain > Engine and ECT > Data List
Tester Display
MAF
50003 234 3

v.

Wait for 30 seconds, and then read the Data List according to the display on the GTS.

Standard Condition:
Tester Display Condition Standard Condition
MAF
·

Engine not running

·

30 seconds after ignition switch turned to ON


0.57 gm/sec. or less


If the result is not as specified, clean the mass air flow meter sub-assembly.

Click hereEngine / Hybrid System>2AR-FE (ENGINE CONTROL)>MASS AIR FLOW METER>INSPECTION

If the result is within the specified range, check the intake air temperature sensor (thermistor) resistance.

Click hereEngine / Hybrid System>2AR-FE (ENGINE CONTROL)>MASS AIR FLOW METER>INSPECTION



Hide 2.PERFORM INITIALIZATION

a.

Perform "Inspection After Repair" after replacing the mass air flow meter sub-assembly.

Click hereEngine / Hybrid System>2AR-FE (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION