11102A
1.REMOVE CAMSHAFT POSITION SENSOR (for Exhaust Side)
Disconnect the camshaft position sensor connector.
Remove the bolt and camshaft position sensor from the cylinder head cover sub-assembly.
If the camshaft position sensor has been struck or dropped, replace it.
12601B
2.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
11102A
3.REMOVE CAMSHAFT POSITION SENSOR (for Intake Side)
Disconnect the camshaft position sensor connector.
Remove the bolt and camshaft position sensor from the cylinder head cover sub-assembly.
If the camshaft position sensor has been struck or dropped, replace it.