Home › Engine / Hybrid System › 2AR-FE (ENGINE CONTROL) › IGNITION COIL AND SPARK PLUG › 2017.09–2021.02
RM33A0E _51 Engine / Hybrid System _065323 2AR-FE ENGINE CONTROL _0319012 IGNITION COIL AND SPARK PLUG A

2AR-FE ENGINE CONTROL  IGNITION COIL AND SPARK PLUG  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed, or replaced during the ignition coil assembly or spark plug removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function when Necessary Procedure not Performed Link
·

Replacement of ignition coil assembly

·

Replacement of spark plug


Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

PROCEDURE

Hide 12601B 1.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 19500 2.REMOVE IGNITION COIL ASSEMBLY

a.
A405033

Disconnect the 4 ignition coil assembly connectors.


b.

Remove the 4 bolts and 4 ignition coil assemblies from the cylinder head cover sub-assembly.

NOTICE:

If an ignition coil assembly has been struck or dropped, replace it.


HINT:

Arrange the removed parts in the correct order.



Hide 19100P 3.REMOVE SPARK PLUG