The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during brake pedal support assembly removal/installation are shown below.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
28800
2.REMOVE BATTERY
for 2AR-FE: Click hereGeneral>MAINTENANCE>2AR-FE BATTERY>REMOVAL
for A25A-FKS: Click hereGeneral>MAINTENANCE>A25A-FKS BATTERY>REMOVAL
for 2GR-FKS: Click hereGeneral>MAINTENANCE>2GR-FKS BATTERY>REMOVAL
3.DRAIN BRAKE FLUID
If brake fluid leaks onto any painted surface, immediately wash it off.
4.DISCONNECT BRAKE LINE
Using a union nut wrench, disconnect the 2 brake lines from the brake master cylinder sub-assembly.
Do not damage or deform the brake lines.
Do not allow any foreign matter such as dirt or dust to enter the brake lines from the connecting parts.
55606
5.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
84340
6.REMOVE STOP LIGHT SWITCH ASSEMBLY
47264A
7.REMOVE PUSH ROD PIN
Remove the clip and push rod pin.
8.REMOVE BRAKE PEDAL SUPPORT ASSEMBLY
Disengage the clamp to separate the wire harness from the brake pedal support assembly.
Remove the bolt and separate the brake pedal support assembly from the instrument panel reinforcement assembly.
|
Nut |
|
Clip |
Remove the 2 clips.
Remove the 4 nuts and push the brake booster assembly toward the engine compartment.
Do not apply excessive force to the brake lines.
Do not apply excessive force to the wire harness.
Remove the brake pedal support assembly while avoiding the stud bolts of the brake booster assembly and brake booster support base.
Be careful not to deform the bracket of the instrument panel reinforcement assembly.
47101A
9.REMOVE BRAKE PEDAL RETURN SPRING
Remove the brake pedal return spring from the brake pedal support assembly.
84345
10.REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER
Disengage the 2 claws and remove the stop light switch mounting adjuster.
47121
11.REMOVE BRAKE PEDAL PAD
Remove the brake pedal pad from the brake pedal support assembly.