The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the battery removal/installation are shown below.
1. PRECAUTION
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When replacing the battery, use a new battery of the same dimensions with a capacity of 60 Ah or more at a 20-hour rate.
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Loosen the nut, and disconnect the cable from the negative (-) battery terminal.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
3.REMOVE BATTERY
| *a | Side View of Claws |
|
Push Battery Terminal Cap Here |
|
Push |
Disengage the 2 claws as shown in the illustration and remove the battery terminal cap from the positive (+) battery terminal.
Loosen the nut and disconnect the cable from the positive (+) battery terminal.
Remove the bolt and No. 2 battery clamp from the battery clamp sub-assembly.
Remove the battery from the vehicle.