Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM WARNING SWITCH › 2017.09–2017.12
RM33A0E _54 Brake _065366 BRAKE SYSTEM (OTHER) _0319136 VACUUM WARNING SWITCH A

BRAKE SYSTEM (OTHER)  VACUUM WARNING SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during vacuum warning switch assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)

PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 28800 2.REMOVE BATTERY

Hide 83390H 3.REMOVE VACUUM WARNING SWITCH ASSEMBLY

a.
C372744

Disconnect the connector from the vacuum warning switch assembly.


b.

Remove the vacuum warning switch assembly from the brake booster assembly.


Hide 44696 4.REMOVE CHECK VALVE GROMMET

a.

Remove the check valve grommet from the brake booster assembly.