Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM WARNING SWITCH › 2017.09–2017.12
RM33A0E _54 Brake _065366 BRAKE SYSTEM (OTHER) _0319136 VACUUM WARNING SWITCH G

BRAKE SYSTEM (OTHER)  VACUUM WARNING SWITCH  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT BRAKE FLUID LEVEL IN RESERVOIR

Hide 44610 2.INSPECT BRAKE BOOSTER ASSEMBLY

Hide 83390H 3.INSPECT VACUUM WARNING SWITCH ASSEMBLY

a.

Start the engine and stop it after 1 or 2 minutes.


b.

Remove the battery.

for A25A-FKS: Click hereGeneral>MAINTENANCE>A25A-FKS BATTERY>REMOVAL

for 2GR-FKS: Click hereGeneral>MAINTENANCE>2GR-FKS BATTERY>REMOVAL


c.

Disconnect the connector from the vacuum warning switch assembly.


d.

Measure the resistance of the vacuum warning switch assembly.

Standard Resistance:

10 kΩ or higher



e.

With the engine stopped, depress the brake pedal several times to release vacuum from the brake booster assembly, and measure the resistance of the vacuum warning switch assembly.

Standard Resistance:

Below 1 Ω



f.

Connect the connector to the vacuum warning switch assembly.


g.

Install the battery.

for A25A-FKS: Click hereGeneral>MAINTENANCE>A25A-FKS BATTERY>INSTALLATION

for 2GR-FKS: Click hereGeneral>MAINTENANCE>2GR-FKS BATTERY>INSTALLATION