The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front drive shaft assembly removal/installation are shown below.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1.REMOVE FRONT WHEELS
53737B
2.REMOVE FRONT FENDER APRON SEAL LH
53736
3.REMOVE FRONT FENDER APRON SEAL RH
4.DRAIN AUTOMATIC TRANSAXLE FLUID
43502H
5.REMOVE FRONT AXLE SHAFT NUT
Using SST and a hammer, release the staked part of the front axle shaft nut.
Fully loosen the staked part of the front axle shaft nut, otherwise the threads of the drive shaft may be damaged.
While applying the brakes, remove the front axle shaft nut.
89543
6.SEPARATE FRONT SPEED SENSOR
45470
7.SEPARATE TIE ROD ASSEMBLY
48810
8.SEPARATE FRONT STABILIZER LINK ASSEMBLY
48069
9.SEPARATE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY
10.SEPARATE FRONT DRIVE SHAFT ASSEMBLY
43420
11.REMOVE FRONT DRIVE SHAFT ASSEMBLY LH
Using SST, remove the front drive shaft assembly LH.
Do not damage the front drive shaft oil seal LH.
Do not damage the front axle inboard joint boot.
Do not drop the front drive shaft assembly LH.
43410
12.REMOVE FRONT DRIVE SHAFT ASSEMBLY RH
Remove the 2 bolts and pull out the drive shaft together with the drive shaft bearing case sub-assembly.
Remove the front drive shaft assembly RH from the drive shaft bearing bracket.
Do not damage the front drive shaft oil seal RH.
Do not damage the front axle inboard joint boot.
Do not drop the front drive shaft assembly RH.
If it is difficult to disengage the fitting, lightly tap the end of the front drive inboard joint assembly using a brass bar and a hammer.
43420G
13.REMOVE FRONT DRIVE SHAFT HOLE SNAP RING
Using a screwdriver, remove the front drive shaft hole snap ring.