Home › Drivetrain › UA80E (AUTOMATIC TRANSMISSION / TRANSAXLE) › PARK / NEUTRAL POSITION SWITCH
RM33A0E _52 Drivetrain _065351 UA80E AUTOMATIC TRANSMISSION / TRANSAXLE _0319439 PARK / NEUTRAL POSITION SWITCH N

UA80E AUTOMATIC TRANSMISSION / TRANSAXLE  PARK / NEUTRAL POSITION SWITCH  ADJUSTMENT  


CAUTION / NOTICE / HINT

NOTICE:

Before adjusting the park/neutral position switch assembly, check that the shift lever is in N.


PROCEDURE

Hide 1.SECURE VEHICLE

a.

Fully apply the parking brake and chock a wheel.

CAUTION:
C332327

·

Make sure to apply the parking brake and chock a wheel before performing this procedure.

·

If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.




Hide 33820B 2.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

Hide 84540 3.ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY

a.
C374455

Disconnect the park/neutral position switch assembly connector.


b.
C374456

Remove the nut, washer and transmission control shaft lever from the manual valve lever shaft sub-assembly.


c.
C374457

Loosen the 2 bolts of the park/neutral position switch assembly.


d.
C374458C01
1.76,0.729 1.833,1.448 1.833,1.448 2.021,1.448 true 1.5,0.573 0.979,1.49 0.979,1.49 0.802,1.49 true 2.052,1.313 2.26,1.531 0.208,0.219 10 true *a 0.573,1.375 0.781,1.563 0.208,0.188 10 true *b
*a Neutral Basic Line
*b Protrusion


Align the protrusion with the neutral basic line.


e.

Hold the park/neutral position switch assembly in position and tighten the 2 bolts.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


f.

Install the transmission control shaft lever to the manual valve lever shaft sub-assembly with the washer and nut.

Torque:
12.7 N*m (130 kgf*cm, 9 ft.*lbf)


g.

Connect the park/neutral position switch assembly connector.


Hide 33820B 4.CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

Hide 84540 5.INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY OPERATION