Home › Drivetrain › UA80E (AUTOMATIC TRANSMISSION / TRANSAXLE) › PARK / NEUTRAL POSITION SWITCH
RM33A0E _52 Drivetrain _065351 UA80E AUTOMATIC TRANSMISSION / TRANSAXLE _0319439 PARK / NEUTRAL POSITION SWITCH A

UA80E AUTOMATIC TRANSMISSION / TRANSAXLE  PARK / NEUTRAL POSITION SWITCH  INSTALLATION  


PROCEDURE

Hide 84540 1.INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

a.

Temporarily install the park/neutral position switch assembly to the automatic transaxle case sub-assembly with the 2 bolts.

NOTICE:

Before installing the park/neutral position switch assembly, remove any dirt or rust on the manual valve lever shaft sub-assembly. Be sure to install the park/neutral position switch assembly straight along the manual valve lever shaft sub-assembly while being careful not to deform the plate spring that supports the manual valve lever shaft sub-assembly. If the plate spring is deformed, the park/neutral position switch assembly cannot be installed correctly.



b.

Temporarily install the transmission control shaft lever to the park/neutral position switch assembly.


c.
C374459C01
0.323,1.698 0.542,1.885 0.219,0.188 10 true *a 1.552,1.958 1.781,2.135 0.229,0.177 10 true *b
*a P
*b N


Turn the transmission control shaft lever clockwise until it stops, then turn it counterclockwise 2 notches.


d.

Remove the transmission control shaft lever from the park/neutral position switch assembly.


e.
C374458C01
1.76,0.729 1.833,1.448 1.833,1.448 2.021,1.448 true 1.5,0.573 0.979,1.49 0.979,1.49 0.802,1.49 true 2.052,1.313 2.26,1.531 0.208,0.219 10 true *a 0.573,1.375 0.781,1.563 0.208,0.188 10 true *b
*a Neutral Basic Line
*b Protrusion


Align the protrusion with the neutral basic line.


f.

Hold the park/neutral position switch assembly in that position and tighten the 2 bolts.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


g.

Install the transmission control shaft lever to the manual valve lever shaft sub-assembly with the washer and nut.

Torque:
12.7 N*m (130 kgf*cm, 9 ft.*lbf)


h.

Connect the park/neutral position switch assembly connector.


Hide 33820B 2.CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

a.
C378151C01
0.74,2.042 1.052,2.198 0.313,0.156 10 false *a 2.146,2.052 2.458,2.208 0.313,0.156 10 false *b
*a Correct
*b Incorrect


Connect the transmission control cable assembly to the transmission control shaft lever as shown in the illustration.

NOTICE:

Before connecting the transmission control cable assembly, check that the park/neutral position switch assembly and shift lever are in N.



Hide 74404A 3.INSTALL BATTERY CLAMP SUB-ASSEMBLY

Hide 28800 5.INSTALL BATTERY

Hide 84540 6.INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY OPERATION