Home › Engine / Hybrid System › A25A-FKS (COOLING) › WATER PUMP › 2017.09–2018.04
RM33A0E _51 Engine / Hybrid System _065346 A25A-FKS COOLING _0319571 WATER PUMP A

A25A-FKS COOLING  WATER PUMP  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the engine water pump assembly (water inlet housing) removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not performed Link
Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)

NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 16031 1.REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY

Hide 16323 2.REMOVE ENGINE WATER PUMP ASSEMBLY (WATER INLET HOUSING)

a.
A407072

Disconnect the sensor wire connector.


b.
A402023

Using an 8 mm socket wrench, remove the bolt and disconnect the sensor wire from the engine water pump assembly (water inlet housing).


c.
A402022

Disconnect the engine water pump assembly (water inlet housing) connector.


d.
A402025

Remove the 4 bolts and engine water pump assembly (water inlet housing) from the cylinder block assembly.


e.
A402026

Remove the gasket from the engine water pump assembly (water inlet housing).