Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
48069
1.INSTALL FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY
Install the front lower arm bushing stopper to the front lower No. 1 suspension arm sub-assembly.
Install the front lower No. 1 suspension arm sub-assembly to the front frame assembly with the 3 bolts and nut in the order shown in the illustration.
Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.
Connect the front lower No. 1 suspension arm sub-assembly to the front lower ball joint assembly with the bolt and 2 nuts.
53737B
2.INSTALL FRONT FENDER APRON SEAL LH
for A25A-FKS: Click hereEngine / Hybrid System>A25A-FKS (ENGINE MECHANICAL)>ENGINE ASSEMBLY>INSTALLATION
for 2GR-FKS: Click hereEngine / Hybrid System>2GR-FKS (ENGINE MECHANICAL)>ENGINE ASSEMBLY>INSTALLATION
58166A
3.INSTALL FRONT FLOOR COVER LH (for A25A-FKS)
51442
4.INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY (for A25A-FKS)
51441
5.INSTALL NO. 1 ENGINE UNDER COVER (for A25A-FKS)
53852K
6.INSTALL FRONT WHEEL OPENING EXTENSION PAD LH (for A25A-FKS)
53851M
7.INSTALL FRONT WHEEL OPENING EXTENSION PAD RH (for A25A-FKS)
8.INSTALL FRONT WHEEL
9.INSPECT AND ADJUST FRONT WHEEL ALIGNMENT