Home › Suspension › FRONT SUSPENSION › FRONT LOWER SUSPENSION ARM (for A25A-FKS, 2GR-FKS) › 2017.09–2017.12
RM33A0E _53 Suspension _065361 FRONT SUSPENSION _0319582 FRONT LOWER SUSPENSION ARM(for A25A-FKS, 2GR-FKS) A

FRONT SUSPENSION  FRONT LOWER SUSPENSION ARM(for A25A-FKS, 2GR-FKS)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front lower No. 1 suspension arm sub-assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Front wheel alignment adjustment Perform system variant learning and acceleration sensor zero point calibration.
·

VSC disabled or malfunctioning

·

DTCs are output

·

Slip indicator light illuminated

·

ABS warning light illuminated


(Click here)
Suspension, tires, etc.
(The vehicle height changes because of suspension or tire replacement)
Rear television camera assembly optical axis (Back camera position setting) Parking assist monitor system for Initialization:(Click here)
for Calibration:(Click here)
Perform headlight ECU sub-assembly LH initialization Lighting system (EXT) (Click here)

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 53852K 2.REMOVE FRONT WHEEL OPENING EXTENSION PAD LH (for A25A-FKS)

Hide 53851M 3.REMOVE FRONT WHEEL OPENING EXTENSION PAD RH (for A25A-FKS)

Hide 51441 4.REMOVE NO. 1 ENGINE UNDER COVER (for A25A-FKS)

Hide 51442 5.REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY (for A25A-FKS)

Hide 58166A 6.REMOVE FRONT FLOOR COVER LH (for A25A-FKS)

Hide 48069 8.REMOVE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY

a.
C370077

Remove the bolt and 2 nuts and separate the front lower No. 1 suspension arm sub-assembly from the front lower ball joint assembly.


b.
C370078

Remove the 3 bolts, nut and front lower No. 1 suspension arm sub-assembly from the front frame assembly.

NOTICE:

Because the nut has its own stopper, do not turn the nut. Loosen the bolt with the nut secured.



c.

Remove the front lower arm bushing stopper from the front lower No. 1 suspension arm sub-assembly.