The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear door belt moulding removal/installation are shown below.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
for 2AR-FE:
Click hereGeneral>MAINTENANCE>2AR-FE BATTERY>REMOVAL
for A25A-FKS:
Click hereGeneral>MAINTENANCE>A25A-FKS BATTERY>REMOVAL
for 2GR-FKS:
74038B
3.REMOVE REAR DOOR ARMREST COVER SUB-ASSEMBLY
4.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL
74260
5.REMOVE REAR ARMREST ASSEMBLY
67604
6.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
68174A
7.REMOVE REAR DOOR INNER GLASS WEATHERSTRIP
67844A
8.REMOVE REAR DOOR NO. 2 SERVICE HOLE COVER
67842E
9.REMOVE REAR DOOR SERVICE HOLE COVER
67848A
10.REMOVE REAR DOOR NO. 1 VENT SEAL
67858B
11.REMOVE REAR DOOR PANEL PROTECTOR
68152C
12.REMOVE REAR DOOR GLASS RUN
67872
13.DISCONNECT REAR DOOR WEATHERSTRIP
67408F
14.REMOVE REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY
68124B
15.REMOVE REAR DOOR QUARTER WINDOW GLASS
68104
16.REMOVE REAR DOOR GLASS SUB-ASSEMBLY
75740
17.REMOVE REAR DOOR BELT MOULDING ASSEMBLY
|
Protective Tape |
Apply protective tape around the rear door belt moulding assembly as shown in the illustration.
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Disengage the 5 claws and guide to remove the rear door belt moulding assembly as shown in the illustration.