The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transmission revolution sensor (NT) and transmission revolution sensor (NC) removal/installation are shown below.
35410
1.REMOVE TRANSMISSION VALVE BODY ASSEMBLY
89413N
2.REMOVE TRANSMISSION REVOLUTION SENSOR (NT)
Remove the bolt and transmission revolution sensor (NT) from the automatic transaxle case sub-assembly.
89413S
3.REMOVE TRANSMISSION REVOLUTION SENSOR (NC)
| *1 | Spacer |
Remove the bolt, spacer and transmission revolution sensor (NC) from the counter drive gear sub-assembly.