The meter mirror sub-assembly receives signals from the radio and display receiver assembly via local bus communication and navigation system information on the headup display.
This DTC is stored when the meter mirror sub-assembly cannot receive the signal.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory | Note |
|---|---|---|---|---|---|
| B132187 | Lost Communication with EMV Missing Message | Diagnosis Condition:
·
The ignition switch is ON ·
IG power source voltage is 9.5 V or more Malfunction Status: No communication with radio and display receiver assembly Malfunction Time: 3.0 seconds or more |
·
Harness or connector ·
Radio and display receiver assembly ·
Combination meter assembly ·
Meter mirror sub-assembly |
DTC stored | - |
Check if navigation system DTCs are output.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
A
B
Check if meter / gauge system DTCs are output.
| Result | Proceed to |
|---|---|
| DTC B132187 is not output | A |
| DTC B132187 is output | B |
A
B