Home › Engine / Hybrid System › 2GR-FKS (ENGINE CONTROL) › IGNITION COIL AND SPARK PLUG
RM33A0E _51 Engine / Hybrid System _065332 2GR-FKS ENGINE CONTROL _0326386 IGNITION COIL AND SPARK PLUG A

2GR-FKS ENGINE CONTROL  IGNITION COIL AND SPARK PLUG  INSTALLATION  


PROCEDURE

Hide 19100P 1.INSTALL SPARK PLUG

Hide 19500 2.INSTALL IGNITION COIL ASSEMBLY

HINT:

Perform "Inspection After Repair" after replacing an ignition coil assembly.

Click hereEngine / Hybrid System>2GR-FKS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION


a.

Install the 3 ignition coil assemblies to the cylinder head cover sub-assembly with the 3 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:

If an ignition coil assembly has been struck or dropped, replace it.


HINT:

Install the same parts to their original positions.



b.

Connect the 3 ignition coil assembly connectors.


c.

Engage the 2 wire harness clamps.


d.

Engage the 4 clamps to install the vacuum hose to the intake air surge tank assembly.


e.

Install the 3 ignition coil assemblies to the cylinder head cover sub-assembly LH with the 3 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:

If an ignition coil assembly has been struck or dropped, replace it.


HINT:

Install the same parts to their original positions.



f.

Connect the 3 ignition coil assembly connectors.


Hide 11209 3.INSTALL V-BANK COVER SUB-ASSEMBLY

Hide 4.PERFORM INITIALIZATION

a.

Perform "Inspection After Repair" after replacing an ignition coil assembly or spark plug.

Click hereEngine / Hybrid System>2GR-FKS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION