Home › Engine / Hybrid System › 2GR-FKS (ENGINE CONTROL) › IGNITION COIL AND SPARK PLUG
RM33A0E _51 Engine / Hybrid System _065332 2GR-FKS ENGINE CONTROL _0326386 IGNITION COIL AND SPARK PLUG A

2GR-FKS ENGINE CONTROL  IGNITION COIL AND SPARK PLUG  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during ignition coil assembly or spark plug removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
·

Replacement of ignition coil assembly

·

Replacement of spark plug


Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

PROCEDURE

Hide 11209 1.REMOVE V-BANK COVER SUB-ASSEMBLY

Hide 19500 2.REMOVE IGNITION COIL ASSEMBLY

a.
A405618

Disconnect the 3 ignition coil assembly connectors.


b.

Remove the 3 bolts and 3 ignition coil assemblies from the cylinder head cover sub-assembly LH.

NOTICE:

If an ignition coil assembly has been struck or dropped, replace it.


HINT:

Arrange the removed parts in the correct order.



c.
A405619

Disengage the 4 clamps to separate the vacuum hose from the intake air surge tank assembly.


d.

Disengage the 2 wire harness clamps.


e.

Disconnect the 3 ignition coil assembly connectors.


f.
A405620

Remove the 3 bolts and 3 ignition coil assemblies from the cylinder head cover sub-assembly.

NOTICE:

If an ignition coil assembly has been struck or dropped, replace it.


HINT:

Arrange the removed parts in the correct order.



Hide 19100P 3.REMOVE SPARK PLUG