84540
1.INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY
Temporarily install the park/neutral position switch assembly to the transaxle case sub-assembly with the 2 bolts.
Before installing the park/neutral position switch assembly, remove any dirt or rust on the manual valve lever shaft sub-assembly. Be sure to install the park/neutral position switch assembly straight along the manual valve lever shaft sub-assembly while being careful not to deform the plate spring that supports the manual valve lever shaft sub-assembly. If the plate spring is deformed, the park/neutral position switch assembly cannot be installed correctly.
| *a | Protrusion |
Align the protrusions of the park/neutral position switch assembly as shown in the illustration.
Hold the park/neutral position switch assembly in that position and tighten the 2 bolts.
After installing the park/neutral position switch assembly, confirm that the protrusions on the park/neutral position switch assembly are aligned.
Install the transmission control shaft lever to the manual valve lever shaft sub-assembly with the washer and nut.
Connect the park/neutral position switch assembly connector.
33820B
2.CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
Connect the transmission control cable assembly to the transmission control shaft lever with the nut.
Before connecting the transmission control cable assembly, check that the park/neutral position switch assembly and shift lever are in N.
74404A
3.INSTALL BATTERY CLAMP SUB-ASSEMBLY
89661
4.INSTALL ECM
28800
5.INSTALL BATTERY
84540
6.INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY OPERATION
7.INSPECT SHIFT LEVER POSITION
8.ADJUST SHIFT LEVER POSITION