33493A
1.INSTALL TRANSMISSION OIL COOLER
Install the transmission oil cooler to the front engine mounting bracket with the 2 bolts.
32941
2.CONNECT INLET NO. 1 OIL COOLER HOSE
| *a | 0 to 3 mm (0 to 0.118 in.) |
| *b | 2 to 7 mm (0.0787 to 0.276 in.) |
| *c | Paint Mark |
Connect the inlet No. 1 oil cooler hose to the transmission oil cooler and slide the clip to secure it.
Make sure to slide the inlet No. 1 oil cooler hose until it contacts the hose stopper of the transmission oil cooler.
Make sure to align the paint mark of the inlet No. 1 oil cooler hose with the paint mark of the transmission oil cooler.
32942
3.CONNECT OUTLET NO. 1 OIL COOLER HOSE
| *a | 0 to 3 mm (0 to 0.118 in.) |
| *b | 2 to 7 mm (0.0787 to 0.276 in.) |
| *c | Paint Mark |
Connect the outlet No. 1 oil cooler hose to the transmission oil cooler and slide the clip to secure it.
Make sure to slide the outlet No. 1 oil cooler hose until it contacts the hose stopper of the transmission oil cooler.
Make sure to align the paint mark of the outlet No. 1 oil cooler hose with the paint mark of the transmission oil cooler.
16267K
4.CONNECT NO. 3 WATER BY-PASS HOSE
| *a | 2 to 7 mm (0.0787 to 0.276 in.) |
| *b | Paint Mark |
| *c | 60° (Claw of Clip Location) |
Connect the No. 3 water by-pass hose to the transmission oil cooler and slide the clip to secure it.
Make sure to slide the No. 3 water by-pass hose until it contacts the hose stopper of the transmission oil cooler.
Make sure to align the paint mark of the No. 3 water by-pass hose with the paint mark of the transmission oil cooler.
Make sure that the claws of the clip are within the location shown in the illustration.
16281N
5.CONNECT NO. 4 WATER BY-PASS HOSE
| *a | 2 to 7 mm (0.0787 to 0.276 in.) |
| *b | Paint Mark |
| *c | 60° (Claw of Clip Location) |
Connect the No. 4 water by-pass hose to the transmission oil cooler and slide the clip to secure it.
Make sure to slide the No. 4 water by-pass hose until it contacts the hose stopper of the transmission oil cooler.
Make sure to align the paint mark of the No. 4 water by-pass hose with the paint mark of the transmission oil cooler.
Make sure that the claws of the clip are within the location shown in the illustration.
17700
6.INSTALL AIR CLEANER ASSEMBLY
17750A
7.INSTALL INLET AIR CLEANER ASSEMBLY
53295E
8.INSTALL COOL AIR INTAKE DUCT SEAL
9.ADD ENGINE COOLANT
10.ADJUST AUTOMATIC TRANSAXLE FLUID
11.INSPECT FOR OIL LEAK
12.INSPECT FOR COOLANT LEAK