Home › Vehicle Exterior › DOOR / HATCH › HOOD LOCK CONTROL CABLE ASSEMBLY › 2017.09–2017.12
RM33A0E _59 Vehicle Exterior _065392 DOOR / HATCH _0326913 HOOD LOCK CONTROL CABLE ASSEMBLY A

DOOR / HATCH  HOOD LOCK CONTROL CABLE ASSEMBLY  INSTALLATION  


PROCEDURE

Hide 53630 1.INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY

a.

Pass the hood lock control cable assembly into the engine compartment.


b.

Engage the grommet.


c.

Engage the 4 clamps to install the hood lock control cable assembly.


d.

for LHD:

i.

Engage the clamp.



Hide 53601 2.INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

a.

Connect the hood lock control cable assembly to install the hood lock control lever sub-assembly.


Hide 53601 3.CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

Hide 55606 4.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)

Hide 55606 5.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)

Hide 62112A 6.INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH (for LHD)

Hide 67914 7.INSTALL FRONT DOOR SCUFF PLATE LH (for LHD)

Hide 53510 8.INSTALL HOOD LOCK ASSEMBLY

a.

Apply MP grease to the sliding areas of the hood lock assembly.


b.

Connect the hood lock control cable assembly to the hood lock assembly.


c.

Install the hood lock assembly with the 2 bolts and hood lock bolt.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)

HINT:

The hood lock nut cap is a non-reusable part. Be sure to install it after inspecting and adjusting the hood sub-assembly.



d.

Connect the connector.


Hide 53295E 9.INSTALL COOL AIR INTAKE DUCT SEAL

Hide 53876A 10.INSTALL FRONT FENDER LINER LH (for LHD)

HINT:

Use the same procedure as for the RH side.

Click hereVehicle Exterior>WIPER / WASHER>WASHER MOTOR>INSTALLATION


Hide 53875A 11.INSTALL FRONT FENDER LINER RH (for RHD)

Hide 53852K 12.INSTALL FRONT WHEEL OPENING EXTENSION PAD LH (for LHD)

HINT:

Use the same procedure as for the RH side.

Click hereVehicle Exterior>WIPER / WASHER>WASHER MOTOR>INSTALLATION


Hide 53851M 13.INSTALL FRONT WHEEL OPENING EXTENSION PAD RH (for RHD)

Hide 14.INSTALL FRONT WHEEL LH (for LHD)

Hide 15.INSTALL FRONT WHEEL RH (for RHD)

Hide 16.ADJUST HOOD SUB-ASSEMBLY