1. CHECK STEERING EFFORT (TORQUE)
These service operations may affect the SRS airbags. Be sure to read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
Stop the vehicle on a level, paved surface and align the wheels straight ahead.
Remove the horn button assembly.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>STEERING PAD>REMOVAL
Connect the cable to the negative (-) battery terminal.
Using a torque wrench, check that the steering wheel set bolt is properly tightened.
Start the engine so that the power steering is ready to operate.
Turn the steering wheel 90 degrees to the right and check steering effort (torque) with the steering wheel turned. Check in the opposite direction using the same method.
5.5 N*m (56 kgf*cm, 49 in.*lbf) or less
Align the front wheels facing straight ahead.
Turn the ignition switch off.
Disconnect the cable from the negative (-) battery terminal.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
Install the horn button assembly.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>STEERING PAD>INSTALLATION