Home › General › INTRODUCTION › REPAIR INSTRUCTION › 2017.09–2017.12
RM33A0E _V1 General _065353 INTRODUCTION _0328185 REPAIR INSTRUCTION D

INTRODUCTION  REPAIR INSTRUCTION  INITIALIZATION  


PROCEDURES NECESSARY WHEN BATTERY TERMINAL IS DISCONNECTED/RECONNECTED


Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)

NOTICE:
·

After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 85 seconds before disconnecting the cable from the negative (-) battery terminal. (for Audio and Visual System)

·

After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 85 seconds before disconnecting the cable from the negative (-) battery terminal. (for Navigation System)




PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED


Replacement Part Necessary Procedure Effect/Inoperative Function when Necessary Procedures are not Performed Link

*1: When the ECM is replaced with a new one, reset memory is unnecessary.

*2: The vehicle height changes because of suspension or tire replacement.

*3: w/ Smart Entry and Start System

*4: w/o Smart Entry and Start System

*5: w/ Occupant Classification System

*6: for 3 Zone Type

ECM Perform Vehicle Identification Number (VIN) or frame number registration MIL comes on (Click here)for 2AR-FE
(Click here)for A25A-FKS
(Click here)for 2GR-FKS
Perform code registration (Immobiliser system) Engine start function See Service Bulletin for the registration method.
for 2AR-FE
·

Throttle body with motor assembly

·

Engine assembly

·

Cylinder head sub-assembly

·

Camshaft

(for intake or exhaust camshaft)

·

Camshaft timing gear assembly

·

Camshaft timing exhaust gear assembly

·

Piston or piston ring

·

Mass air flow meter sub-assembly

·

Fuel injector assembly

·

Fuel pump

·

Air fuel ratio sensor

·

Engine coolant temperature sensor

·

Spark plug

·

Ignition coil assembly

·

Air intake system parts

·

Exhaust system parts

·

Knock control sensor


Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)
for A25A-FKS
·

Throttle body with motor assembly

·

Cam timing control motor with EDU assembly

·

Camshaft timing gear assembly

·

Engine assembly

·

Cylinder head sub-assembly

·

Camshaft (for intake or exhaust camshaft)

·

Camshaft timing exhaust gear assembly

·

Piston or piston ring

·

Mass air flow meter sub-assembly

·

Port fuel injector assembly

·

Direct fuel injector assembly

·

Fuel pump (for low pressure side)

·

Fuel pump assembly (for high pressure side)

·

Fuel pressure sensor (fuel delivery pipe with sensor sub-assembly) (for low pressure side)

·

Fuel pressure sensor (for high pressure side)

·

Air fuel ratio sensor (sensor 1)

·

Air fuel ratio sensor (sensor 2)

·

Engine coolant temperature sensor

·

Spark plug

·

Ignition coil assembly

·

EGR valve assembly

·

Air intake system parts

·

Exhaust system parts

·

Knock control sensor


Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)
for 2GR-FKS
·

Throttle body with motor assembly

·

Engine assembly

·

Cylinder head sub-assembly

·

Camshaft (for intake or exhaust camshaft)

·

Camshaft timing gear assembly

·

Camshaft timing exhaust gear assembly

·

Piston or piston ring

·

Mass air flow meter sub-assembly

·

Fuel injector assembly (for port injection)

·

Fuel injector assembly (for direct injection)

·

Fuel pump (for low pressure side)

·

Fuel pump assembly (for high pressure side)

·

Fuel pressure sensor (for low pressure side)

·

Fuel pressure sensor (for high pressure side)

·

Air fuel ratio sensor

·

Engine coolant temperature sensor

·

Spark plug

·

Ignition coil assembly

·

Air intake system parts

·

Exhaust system parts

·

Knock control sensor


Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)
Millimeter wave radar sensor assembly Adjust millimeter wave radar sensor assembly
·

Dynamic radar cruise control system

·

Forward recognition camera system

·

Lane departure alert system (w/ Steering Control)

·

Pre-collision system


(Click here)
·

Forward recognition camera

·

Windshield glass


Adjust forward recognition camera
·

Dynamic radar cruise control system

·

Forward recognition camera system

·

Lane departure alert system (w/ Steering Control)

·

Pre-collision system

·

Lighting system (EXT)


(Click here)
Automatic transaxle assembly
1.

Reset memory

2.

Input transaxle compensation code into ECM

3.

Perform road test to allow ECM to learn


·

Large shift shock

·

Deterioration of fuel efficiency


(Click here)for UA80E Initialization
(Click here)for UA80E Registration
·

Transmission valve body assembly

·

Solenoid (SL1, SL2, SL3, SL4, SL5 and/or SL6) valve


1.

Reset memory

2.

Reset transaxle compensation code

3.

Perform road test to allow ECM to learn


ECM
(If possible, read the transaxle compensation code from the previous ECM)
1.

Reset memory*1

2.

Transfer transaxle compensation code

3.

Perform road test to allow ECM to learn


ECM
(If impossible, read the transaxle compensation code from the previous ECM)
1.

Reset memory*1

2.

Reset transaxle compensation code

3.

Perform road test to allow ECM to learn


Automatic transaxle assembly
1.

Reset memory

2.

Input transaxle compensation code into ECM

3.

Perform road test to allow ECM to learn


·

Large shift shock

·

Deterioration of fuel efficiency


(Click here)for UB80E Initialization
(Click here)for UB80E Registration
·

Transmission valve body assembly

·

Solenoid (SL1, SL2, SL3, SL4, SL5 and/or SL6) valve


1.

Reset memory

2.

Reset transaxle compensation code

3.

Perform road test to allow ECM to learn


ECM
(If possible, read the transaxle compensation code from the previous ECM)
1.

Reset memory*1

2.

Transfer transaxle compensation code

3.

Perform road test to allow ECM to learn


ECM
(If impossible, read the transaxle compensation code from the previous ECM)
1.

Reset memory*1

2.

Reset transaxle compensation code

3.

Perform road test to allow ECM to learn


Automatic transaxle assembly Perform the following procedures in the order shown:
1.

Reset Memory

2.

Input transaxle compensation code into ECM

3.

Perform road test to allow ECM to learn


·

Large shift shock

·

The deterioration of fuel efficiency


(Click here)for U760E Initialization
(Click here)for U760E Registration
·

Valve body assembly

·

Shift solenoid valve SL3 and/or SL4


Perform the following procedures in the order shown:
1.

Reset Memory

2.

Reset transaxle compensation code

3.

Perform road test to allow ECM to learn


Shift solenoid valve SL1 and/or SL2 Perform road test to allow ECM to learn
ECM (If possible, read the transaxle compensation code from the previous ECM) Possible Perform the following procedures in the order shown:
1.

Reset Memory

2.

Transfer transaxle compensation code

3.

Perform road test to allow ECM to learn


Impossible Perform the following procedures in the order shown:
1.

Reset Memory

2.

Reset transaxle compensation code

3.

Perform road test to allow ECM to learn


Automatic transaxle fluid ATF thermal degradation estimate reset The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly. (Click here)
·

Tire pressure warning ECU and receiver

·

Tire pressure warning valve and transmitter


·

Register Transmitter ID

·

Initialize tire pressure warning system


·

When DTC detection conditions of "transmitter ID not received" DTC are met, TPWS indicator blinks for 1 minute, and then illuminates.

·

Tire pressure warning function


(Click here)for Registration
(Click here)for Initialization
·

Skid control ECU (brake actuator assembly)

·

Yaw rate and acceleration sensor (airbag sensor assembly)


Perform system variant learning and acceleration sensor zero point calibration.
·

VSC disabled or malfunctioning

·

DTCs are output

·

Slip indicator light illuminated

·

ABS warning light illuminated


(Click here)
Skid control ECU (brake actuator assembly) Operate the electric parking brake switch (electric parking brake switch assembly) Parking brake indicator light (red) blinks when the engine switch is first turned on (IG) (Click here)
Rack and pinion power steering gear assembly
·

Perform torque sensor zero point calibration

·

Assist Map Writing


·

DTCs are output

·

Steering effort different between turning steering wheel left and right

·

EPS warning light illuminates


(Click here)
·

Clearance warning ECU assembly

·

Ultrasonic sensor


Adjust TOYOTA parking assist-sensor system TOYOTA parking assist-sensor system (Click here)
Steering sensor
·

Steering angle neutral point (Initialize parking assist monitor system)

·

Steering angle setting


Parking assist monitor system (Click here)for Initialization
(Click here)for Calibration
Suspension, tires*2 Rear television camera assembly optical axis (Back camera position setting)
Rear television camera assembly
·

Parking assist monitor system initialization

·

Rear television camera assembly optical axis (Back camera position setting)


Blind spot monitor sensor Blind spot monitor beam axis adjustment Blind spot monitor system (Click here)
·

Certification ECU (smart key ECU assembly)*3

·

Steering lock ECU (steering lock actuator or upper bracket assembly)*3

·

Electrical key transmitter sub-assembly*3

·

ECM*3

·

Main body ECU (multiplex network body ECU)*3


Perform code registration (Immobiliser function)
·

Wireless door lock control system

·

Smart Entry and Start System (for Entry Function)

·

Smart Entry and Start System (for Start Function)

·

Steering lock function


See Service Bulletin for the registration method.
·

Transponder key ECU assembly*4

·

Door control transmitter module set sub-assembly*4

·

ECM*4


Perform code registration (Immobiliser system)
·

Wireless door lock control system

·

Engine start


See Service Bulletin for the registration method.
·

Occupant detection ECU

·

Front passenger seat*5


Zero point calibration (Occupant classification system)
·

Occupant classification system

·

Passenger airbag ON/OFF indicator

·

Airbag system (Front passenger side)

·

Seat belt warning system (Front passenger)


(Click here)
·

Position control ECU assembly (driver seat)

·

Front seatback frame sub-assembly (driver seat)

·

Front seat adjuster assembly (driver seat)

·

Slide motor (upper seat track rail sub-assembly (driver seat))

·

Power seat tilt motor assembly (driver seat)

·

Power seat lifter motor assembly (driver seat)


Initialize position control ECU Front Power Seat Control System (Click here)
·

No. 1 air conditioning radiator damper servo sub-assembly

·

No. 2 air conditioning radiator damper servo sub-assembly

·

No. 3 air conditioning radiator damper servo sub-assembly*6

·

No. 1 blower damper servo sub-assembly

·

Air conditioning amplifier assembly


Servo motor initialization (Air conditioning system) DTCs are output (Click here)
·

Door window regulator sub-assembly

·

Power window regulator motor sub-assembly

·

Door glass

·

Door glass run


Initialize power window control system
·

Auto up and down function

·

Jam protection function

·

Remote control function

·

Key-linked function

·

Wireless transmitter-linked function

·

Key-off operation function

·

Catch protection function

·

Window open warning function


(Click here)
·

Sliding roof ECU (sliding roof drive gear)

·

Slide roof housing panel

·

Slide roof rail sub-assembly

·

Sliding roof glass sub-assembly


Initialize panoramic moon roof system (for Sliding Roof)
·

Auto operation function

·

Jam protection function

·

Key-off operation function

·

Key-linked function

·

Wireless transmitter linked function

·

Sliding roof open warning function


(Click here)
·

Roof sunshade ECU (sliding roof drive gear assembly)

·

Sunshade trim sub-assembly

·

Slide roof rail sub-assembly


Initialize panoramic moon roof system (for Roof Sunshade)
·

Auto operation function

·

Jam protection function

·

Key-off operation function


Headlight ECU sub-assembly LH
·

Synchronize the vehicle information

·

Perform headlight ECU sub-assembly LH initialization


Lighting system (EXT) (Click here)
·

Rear height control sensor sub-assembly LH

·

Suspension, tires*2


Perform headlight ECU sub-assembly LH initialization