Home › Engine / Hybrid System › 2GR-FKS (ENGINE MECHANICAL) › FRONT CRANKSHAFT OIL SEAL
RM33A0E _51 Engine / Hybrid System _065333 2GR-FKS ENGINE MECHANICAL _0327368 FRONT CRANKSHAFT OIL SEAL A

2GR-FKS ENGINE MECHANICAL  FRONT CRANKSHAFT OIL SEAL  INSTALLATION  


PROCEDURE

Hide 11301C 1.INSTALL TIMING CHAIN CASE OIL SEAL

a.
A369432C01
1.552,1.219 0.76,1.719 0.76,1.719 1.313,2.573 true 3.052,0.156 3.365,0.313 0.313,0.156 10 false *a 0.438,1.635 0.896,1.833 0.458,0.198 10 false SST
*a Oil Seal Protrusion Height


Apply MP grease to the lip of a new timing chain case oil seal.


b.

Using SST and a hammer, tap in the timing chain case oil seal until its surface is flush with the timing chain cover assembly edge.

SST
09316-60012  (09316-00011)

Oil Seal Protrusion Height:

0 to 1.0 mm (0 to 0.0394 in.)


NOTICE:
·

Keep the lip free from foreign matter.

·

Do not tap in the timing chain case oil seal at an angle.




Hide 13471 2.INSTALL CRANKSHAFT PULLEY

a.

Align the pulley set key with the key groove of the crankshaft pulley.


b.
A369433C01
1.24,2.313 0.979,0.594 true 0.875,1.813 0.969,0.583 0.969,0.583 2.156,0.854 true 0.302,0.979 0.615,1.135 0.313,0.156 10 false *a 0.792,0.354 1.25,0.552 0.458,0.198 10 false SST
*a Hold
V100135

Turn


Using SST to hold the crankshaft pulley in place, tighten the crankshaft pulley set bolt.

SST
09213-70011  (09213-70020)
09330-00021  

Torque:
260 N*m (2651 kgf*cm, 192 ft.*lbf)


Hide 16361A 3.INSTALL V-RIBBED BELT

Hide 4.INSTALL ENGINE ASSEMBLY WITH TRANSAXLE