The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during front crankshaft oil seal removal/installation are shown below.
*1: When the ECM is replaced with a new one, reset memory is unnecessary.
1.REMOVE ENGINE ASSEMBLY WITH TRANSAXLE
16361A
2.REMOVE V-RIBBED BELT
13471
3.REMOVE CRANKSHAFT PULLEY
| *a | Hold |
|
Turn |
Using SST to hold the crankshaft pulley, loosen the crankshaft pulley set bolt. Further loosen the crankshaft pulley set bolt until 2 or 3 threads remain screwed into the crankshaft.
| *a | Hold |
|
Turn |
Using SST, remove the crankshaft pulley set bolt and crankshaft pulley.
11301C
4.REMOVE TIMING CHAIN CASE OIL SEAL
| *a | Protective Tape |
Using a screwdriver with its tip wrapped with protective tape, pry out the timing chain case oil seal.
After removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.