Home › Vehicle Interior › SEAT BELT › SEAT BELT WARNING SYSTEM (w/ Occupant Classification System)
RM33A0E _58 Vehicle Interior _065386 SEAT BELT _0327385 SEAT BELT WARNING SYSTEM(w/ Occupant Classification System) U

SEAT BELT  SEAT BELT WARNING SYSTEM(w/ Occupant Classification System)  TERMINALS OF ECU  


CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) AND INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY (w/ Rear Seat Belt Warning)


B472410N33
1.125,3.25 1.563,3.5 0.438,0.25 3.156,3.219 3.594,3.469 0.438,0.25 5.448,3.208 5.885,3.458 0.438,0.25 1.698,4.573 2.135,4.823 0.438,0.25 5.385,4.573 5.823,4.823 0.438,0.25 1.104,6.167 1.542,6.417 0.438,0.25 3.667,6.125 4.104,6.375 0.438,0.25 5.292,6.198 5.729,6.448 0.438,0.25 6.313,6.198 6.75,6.448 0.438,0.25 3.365,7.646 3.802,7.896 0.438,0.25 1.656,1.208 1.958,1.208 false 1.667,1.552 1.969,1.552 false 1.667,1.875 1.969,1.875 false 4.042,0.792 4.042,0.313 4.042,0.313 4.229,0.313 false 3.469,7.698 3.781,7.896 0.313,0.198 10 false MB 4.292,0.24 4.604,0.438 0.313,0.198 10 false MB 2.042,1.135 2.354,1.333 0.313,0.198 10 false K51 2.052,1.479 2.365,1.677 0.313,0.198 10 false K52 2.052,1.802 2.365,2 0.313,0.198 10 false K53 0.875,1.083 1.188,1.281 0.313,0.198 10 false 3D 0.875,1.667 1.188,1.865 0.313,0.198 10 false 3C 0.885,2.031 1.198,2.229 0.313,0.198 10 false 3E 0.906,2.26 1.219,2.458 0.313,0.198 10 false 3F 5.854,1.146 6.167,1.344 0.313,0.198 10 false 3B 5.854,1.76 6.167,1.958 0.313,0.198 10 false 3A 1.219,3.302 1.531,3.5 0.313,0.198 10 false K53 3.25,3.271 3.563,3.469 0.313,0.198 10 false K52 5.542,3.26 5.854,3.458 0.313,0.198 10 false K51 1.844,4.625 2.156,4.823 0.313,0.198 10 false 3A 1.229,6.219 1.542,6.417 0.313,0.198 10 false 3C 3.792,6.167 4.104,6.365 0.313,0.198 10 false 3D 5.427,6.25 5.74,6.448 0.313,0.198 10 false 3F 6.448,6.25 6.76,6.448 0.313,0.198 10 false 3E 5.51,4.625 5.823,4.823 0.313,0.198 10 false 3B

a.

Disconnect the instrument panel junction block assembly and main body ECU (multiplex network body ECU) connectors.

Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL


b.

Reconnect the instrument panel junction block assembly connectors.


c.

Measure the resistance and voltage according to the value(s) in the table below.

HINT:

Measure the values on the wire harness side with the connector disconnected.


Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
MB-31 (BECU) - Body ground - Battery power supply Always 11 to 14 V
MB-32 (IG) - Body ground - Ignition power supply (IG signal) Engine switch on (IG) 11 to 14 V
Engine switch off Below 1 V
MB-30 (ACC) - Body ground - Ignition power supply (ACC signal) Engine switch on (ACC) 11 to 14 V
Engine switch off Below 1 V
MB-11 (GND1) - Body ground - Ground Always Below 1 Ω
MB-2 (RCTY) - Body ground - Rear door courtesy light switch RH input Rear door RH closed (OFF) 10 kΩ or higher
Rear door RH open (ON) Below 1 Ω
MB-13 (LCTY) - Body ground - Rear door courtesy light switch LH input Rear door LH closed (OFF) 10 kΩ or higher
Rear door LH open (ON) Below 1 Ω



CHECK COMBINATION METER ASSEMBLY


B345456N11
3.427,0.208 3.813,0.427 0.385,0.219 3.5,0.229 3.813,0.427 0.313,0.198 10 false K21

a.

Disconnect the K21 combination meter assembly connector.


b.

Measure the resistance and voltage according to the value(s) in the table below.

HINT:

Measure the values on the wire harness side with the connector disconnected.


Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
K21-40 (B) - Body ground LA-B - Body ground Battery power supply Always 11 to 14 V
K21-39 (IG+) - Body ground LA-GR Body ground Ignition power supply Engine switch off Below 1 V
Engine switch on (IG) 11 to 14 V
K21-21 (ES) - Body ground W-B - Body ground Ground Always Below 1 Ω
K21-24 (RLSB) - Body ground SB - Body ground Rear LH seat belt buckle switch signal Rear LH seat belt fastened 10 kΩ or higher
Rear LH seat belt unfastened Below 1 Ω
K21-26 (RRSB) - Body ground LG - Body ground Rear RH seat belt buckle switch signal Rear RH seat belt fastened 10 kΩ or higher
Rear RH seat belt unfastened Below 1 Ω
K21-25 (RCSB) - Body ground B - Body ground Rear center seat belt buckle switch signal Rear center seat belt fastened 10 kΩ or higher
Rear center seat belt unfastened Below 1 Ω


c.

Reconnect the K21 combination meter assembly connector.


d.

Measure the voltage according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
K21-18 (RLMT) - Body ground BE - Body ground Rear LH seat belt warning light output signal Engine switch on (IG), rear seat belt warning light (LH) off 11 to 14 V
Engine switch on (IG), rear seat belt warning light (LH) on Below 1 V
K21-19 (RCMT) - Body ground R - Body ground Rear center seat belt warning light output signal Engine switch on (IG), rear seat belt warning light (center) off 11 to 14 V
Engine switch on (IG), rear seat belt warning light (center) on Below 1 V
K21-20 (RRMT) - Body ground G - Body ground Rear RH seat belt warning light output signal Engine switch on (IG), rear seat belt warning light (RH) off 11 to 14 V
Engine switch on (IG), rear seat belt warning light (RH) on Below 1 V



AIRBAG SENSOR ASSEMBLY


C370780N04
1.813,0.26 2.24,0.51 0.427,0.25 3.333,0.26 3.76,0.5 0.427,0.24 4.917,0.25 5.333,0.5 0.417,0.25 1.917,0.302 2.229,0.5 0.313,0.198 10 false R32 3.438,0.292 3.896,0.49 0.458,0.198 10 false K73 5.01,0.292 5.469,0.49 0.458,0.198 10 false R31

Terminal No. Terminal Symbol Destination
R32-28 LBE+ Front seat inner belt assembly LH
R32-27 LBE- Front seat inner belt assembly LH


CHECK OCCUPANT DETECTION ECU


C238368N38
4.25,0.083 4.646,0.323 0.396,0.24 2.604,0.073 3,0.313 0.396,0.24 2.688,0.104 3.156,0.438 0.469,0.333 10 false a19 4.333,0.115 4.74,0.302 0.406,0.188 10 false a20

a.

Measure the voltage and check for pulses according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
a20-10 (GND) - Body ground W-B - Body ground Ground Always Below 1 V
a20-6 (IG2) - a20-10 (GND) B - W-B Power source Engine switch on (IG) 11 to 14 V
a20-9 (BGND) - a20-10 (GND) P - W-B Front passenger buckle switch ground Always Below 1 V
a20-7 (BSW) - a20-9 (BGND) G - P Front passenger buckle switch signal Always Pulse generation
a19-1 (SVC1) - a19-5 (SGD1) R - G Front occupant classification sensor LH power supply Engine switch on (IG) 11 to 14 V
a19-2 (SVC3) - a19-6 (SGD3) GR - W Rear occupant classification sensor LH power supply Engine switch on (IG) 11 to 14 V
a19-3 (SIG1) - a19-5 (SGD1) P - G Front occupant classification sensor LH signal Engine switch on (IG) Pulse generation
a19-4 (SIG3) - a19-6 (SGD3) SB - W Rear occupant classification sensor LH signal Engine switch on (IG) Pulse generation
a19-5 (SGD1) - a20-10 (GND) G - W-B Front occupant classification sensor LH ground Always Below 1 V
a19-6 (SGD3) - a20-10 (GND) W - W-B Rear occupant classification sensor LH ground Always Below 1 V