897B0
1.INSTALL TIRE PRESSURE WARNING ECU AND RECEIVER
Do not drop, strike or otherwise subject the tire pressure warning ECU and receiver to impact.
If the tire pressure warning ECU and receiver is subjected to an impact, replace it with a new one.
| *A | for Type A |
| *B | for Type B |
Connect the connector.
Engage the 2 guides and install the tire pressure warning ECU and receiver with the bolt.
There are three types of bolts and the tightening torque depends on the type of bolt used as shown in the illustration. Therefore, confirm the tightening torque before installing the bolt.
62471A
2.INSTALL INNER ROOF SIDE GARNISH RH
Use the same procedure as for the LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION
3.INSTALL REAR SIDE SEATBACK ASSEMBLY RH
Use the same procedure as for the LH side.
Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY (for Fold Down Seat Type)>INSTALLATION
62331A
4.INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH
72693
5.INSTALL REAR SEAT CUSHION LOCK HOOK
6.INSTALL REAR SEAT CUSHION ASSEMBLY
73350C
7.CONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY
8.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
9. REGISTER TRANSMITTER ID
10.INSPECT TIRE PRESSURE WARNING SYSTEM
11.PERFORM INITIALIZATION
12. PERFORM DIAGNOSTIC SYSTEM CHECK
13.INSPECT SRS WARNING LIGHT