Home › Suspension › FRONT SUSPENSION › FRONT LOWER SUSPENSION ARM(for 2AR-FE RH Side) › 2017.09–2017.12
RM33A0E _53 Suspension _065361 FRONT SUSPENSION _0327270 FRONT LOWER SUSPENSION ARM(for 2AR-FE RH Side) A

FRONT SUSPENSION  FRONT LOWER SUSPENSION ARM(for 2AR-FE RH Side)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front lower No. 1 suspension arm sub-assembly RH removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Front wheel alignment adjustment Perform system variant learning and acceleration sensor zero point calibration.
·

VSC disabled or malfunctioning

·

DTCs are output

·

Slip indicator light illuminated

·

ABS warning light illuminated


(Click here)
Suspension, tires, etc.
(The vehicle height changes because of suspension or tire replacement)
Rear television camera assembly optical axis (Back camera position setting) Parking assist monitor system for Initialization:(Click here)
for Calibration:(Click here)
Perform headlight ECU sub-assembly LH initialization Lighting system (EXT) (Click here)

PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 53736 2.REMOVE FRONT FENDER APRON SEAL RH

Hide 48068 3.REMOVE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH

a.
C373237

Remove the bolt and 2 nuts and separate the front lower No. 1 suspension arm sub-assembly RH from the front lower ball joint assembly RH.


b.
C373238

Remove the 3 bolts, nut and front lower No. 1 suspension arm sub-assembly RH from the front frame assembly.

NOTICE:

Because the nut has its own stopper, do not turn the nut. Loosen the bolt with the nut secured.



c.

Remove the front lower arm bushing stopper from the front lower No. 1 suspension arm sub-assembly RH.