89835
1.INSTALL DOOR SIDE AIRBAG SENSOR
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Before connecting the connector, check that the position of the white housing lock is as shown in the illustration.
| *a | Incorrect | *b | Correct |
| *a | Stopper |
Insert the door side airbag sensor stopper into the door hole, engage the claw and install the door side airbag sensor to the front door panel with the nut.
If the door side airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
When installing the door side airbag sensor, make sure that the SRS wiring does not interfere with or is not pinched between other parts.
Make sure that the door side airbag sensor stopper is securely inserted into the door hole.
Keep the stud bolt and waterproof rubber seal free of foreign matter.
Connect the connector to the door side airbag sensor.
| *a | White Housing Lock | *b | Connection is completed |
When connecting any airbag connector, take care not to damage the airbag wire harness.
Be sure to connect the connector until it is locked (when locking, make sure that a click sound can be heard).
When the connector is locked, the white housing lock will slide. Do not hold the white housing lock or the part (A) as it may result in an insecure connection.
Check that there is no looseness in the installed parts of the door side airbag sensor.
67832
2.INSTALL FRONT DOOR SERVICE HOLE COVER
67602
3.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY
81230
4.INSTALL COURTESY LIGHT ASSEMBLY
74220
5.INSTALL FRONT ARMREST ASSEMBLY
6.INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)
7.INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)
74038A
8.INSTALL FRONT DOOR ARMREST COVER SUB-ASSEMBLY
67492A
9.INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH
10.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
for 2AR-FE: Click hereGeneral>MAINTENANCE>2AR-FE BATTERY>INSTALLATION
for A25A-FKS: Click hereGeneral>MAINTENANCE>A25A-FKS BATTERY>INSTALLATION
for 2GR-FKS: Click hereGeneral>MAINTENANCE>2GR-FKS BATTERY>INSTALLATION
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
11.INSPECT POWER WINDOW OPERATION
12. PERFORM DIAGNOSTIC SYSTEM CHECK
13.INSPECT SRS WARNING LIGHT