Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION ECU › 2017.09–2021.02
RM33A0E _56 Audio / Visual / Telematics _065374 NAVIGATION / MULTI INFO DISPLAY _0328083 NAVIGATION ECU A

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION ECU  INSTALLATION  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:
·

When replacing the radio and display receiver assembly or navigation ECU, always replace it with a new one. If a radio and display receiver assembly or navigation ECU which was installed to another vehicle is used, the following may occur:

-

A communication malfunction DTC may be stored.

-

The radio and display receiver assembly or navigation ECU may not operate normally.


·

After replacing the navigation ECU, if "New software is not compatible with the system. Contact your dealer." is displayed on the multi-display, update the software of the radio and display receiver assembly.



Hide 86841 2.INSTALL NAVIGATION ECU

Hide 86140A 3.INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY

Hide 86212C 4.INSTALL NO. 2 RADIO RECEIVER BRACKET

Hide 86211J 5.INSTALL NO. 1 RADIO RECEIVER BRACKET

Hide 86842 6.INSTALL NO. 1 NAVIGATION WIRE

a.

Connect the 3 connectors to install the No. 1 navigation wire.


Hide 86453 7.INSTALL MULTI-MEDIA MODULE WIRE

Hide 8.INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET

Hide 55670 9.INSTALL NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 55480D 10.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY

Hide 55012A 11.INSTALL NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY

Hide 55435B 12.INSTALL NO. 1 METER HOOD CLUSTER

Hide 13. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM (for Power Tilt and Power Telescopic Steering Column)