Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM › 2017.09–2021.02
RM33A0E _56 Audio / Visual / Telematics _065374 NAVIGATION / MULTI INFO DISPLAY _0328126 NAVIGATION SYSTEM C

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  B153A  GVIF Disconnected (from Extension Module to H/U)  


DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area
B153A GVIF Disconnected (from Extension Module to H/U) GVIF disconnected (from navigation ECU to radio and display receiver assembly)
·

No. 1 navigation wire

·

Navigation ECU

·

Radio and display receiver assembly



WIRING DIAGRAM

E367999E02
1.281,0.844 1.719,1.083 0.438,0.24 10 false GVO+ 0.802,2.177 1.24,2.417 0.438,0.24 10 false r1 0.792,2.333 1.833,2.583 1.042,0.25 10 false Navigation ECU 0.885,3.385 1.865,3.625 0.979,0.24 10 false : GVIF Cable 3,2.021 4.438,2.323 1.438,0.302 10 false No. 1 Navigation Wire 1.854,0.719 2.292,0.958 0.438,0.24 10 false 2 1.854,1.177 2.292,1.417 0.438,0.24 10 false 1 1.854,1.656 2.292,1.896 0.438,0.24 10 false 3 1.323,1.292 1.76,1.531 0.438,0.24 10 false GVO- 1.313,1.74 1.75,1.979 0.438,0.24 10 false GVG1 5.458,0.854 5.896,1.094 0.438,0.24 10 false GV2+ 5.469,1.281 5.906,1.521 0.438,0.24 10 false GV2- 5.479,1.74 5.917,1.979 0.438,0.24 10 false GVG2 5.313,2.167 5.75,2.406 0.438,0.24 10 false r2 5.323,2.323 6.719,2.75 1.396,0.427 10 false Radio and Display Receiver Assembly 5.219,1.646 5.656,1.885 0.438,0.24 10 false 3 5.208,1.177 5.646,1.417 0.438,0.24 10 false 1 5.198,0.729 5.635,0.969 0.438,0.24 10 false 2

CAUTION / NOTICE / HINT

NOTICE:
·

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>PRECAUTION

·

When replacing the radio and display receiver assembly or navigation ECU, always replace it with a new one. If a radio and display receiver assembly or navigation ECU which was installed to another vehicle is used, the following may occur:

-

A communication malfunction DTC may be stored.

-

The radio and display receiver assembly or navigation ECU may not operate normally.




PROCEDURE

1.CHECK DTC
a.

Clear the DTCs.

Body Electrical > Navigation System > Clear DTCs
50002 212

b.

Recheck for DTCs and check that no DTCs are output.

Body Electrical > Navigation System > Trouble Codes
50001 212
OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

NG

2.CHECK NO. 1 NAVIGATION WIRE (RADIO AND DISPLAY RECEIVER ASSEMBLY - NAVIGATION ECU)
2.CHECK NO. 1 NAVIGATION WIRE (RADIO AND DISPLAY RECEIVER ASSEMBLY - NAVIGATION ECU)
a.
E368007C01
1.49,0.5 1.906,0.75 0.417,0.25 1.479,2.667 1.896,2.917 0.417,0.25 1.156,2.031 1.354,2.031 1.354,2.031 1.708,1.469 true 1.813,1.333 2.219,0.979 2.219,0.979 2.427,0.979 true 1.031,0.906 1.219,0.906 1.219,0.906 1.615,1.354 true 1.542,3.427 1.938,4.135 1.938,4.135 2.156,4.135 true 0.823,2.979 1.01,2.979 1.01,2.979 1.406,3.427 true 0.917,4.146 1.115,4.146 1.115,4.146 1.469,3.583 true 0.271,0.146 0.583,0.302 0.313,0.156 10 false *a 0.323,2.448 0.635,2.604 0.313,0.156 10 false *b 1.635,0.542 1.948,0.698 0.313,0.156 10 false r2 1.625,2.708 1.938,2.865 0.313,0.156 10 false r1 2.479,0.896 3.052,1.125 0.573,0.229 10 false GV2+ 0.635,0.813 1.208,1.042 0.573,0.229 10 false GV2- 0.729,1.948 1.302,2.177 0.573,0.229 10 false GVG2 0.479,4.052 1.052,4.281 0.573,0.229 10 false GVG1 0.427,2.885 1,3.115 0.573,0.229 10 false GVO- 2.208,4.052 2.781,4.281 0.573,0.229 10 false GVO+
*a Front view of wire harness connector
(to Radio and Display Receiver Assembly)
*b Front view of wire harness connector
(to Navigation ECU)


Disconnect the r1 navigation ECU connector.


b.

Disconnect the r2 radio and display receiver assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
r1-1 (GVO-) - r2-1 (GV2-) Always Below 1 Ω
r1-2 (GVO+) - r2-2 (GV2+) Always Below 1 Ω
r1-3 (GVG1) - r2-3 (GVG2) Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

3.REPLACE NAVIGATION ECU

NG

3.REPLACE NAVIGATION ECU
a.

Replace the Navigation ECU with a new one.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION ECU>REMOVAL


Result:
Proceed to
NEXT



NEXT

4.CHECK DTC
4.CHECK DTC
a.

Clear the DTCs.

Body Electrical > Navigation System > Clear DTCs
50002 212

b.

Recheck for DTCs and check that no DTCs are output.

Body Electrical > Navigation System > Trouble Codes
50001 212
OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

END (NAVIGATION ECU IS DEFECTIVE)

NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY