CHECK DTCs (USING GTS)
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / EMPS / Trouble Codes.
Check the details of the DTCs.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DIAGNOSTIC TROUBLE CODE CHART
CHECK DTCs (USING SST CHECK WIRE)
| *a | DLC3 |
Using SST, connect terminals K68-13 (TC) and K68-4 (CG) of the DLC3.
Turn the ignition switch to ON.
| *a | Normal System Code |
| *b | Codes 21 and 22 |
| *c | ON |
| *d | OFF |
| *e | Seconds |
| *f | Code 21 |
| *g | Code 22 |
Read and write down any DTCs indicated by the blinking of the EPS warning light in the combination meter assembly. Refer to the illustration to the right for examples of the normal system code and DTCs 21 and 22.
If two or more malfunctions are detected simultaneously, DTCs will be displayed in ascending numerical order.
Refer to Diagnostic Trouble Code Chart for DTC information.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DIAGNOSTIC TROUBLE CODE CHART
Check the details of the DTCs.
| EPS Warning Light Display | Tester Display |
|---|---|
| 11 | C1511 |
| C1512 | |
| C1513 | |
| C1514 | |
| 12 | C1528 |
| 13 | C1541 |
| 15 | C1515 |
| 16 | C1516 |
| 22 | C1552 |
| 23 | C1554 |
| 24 | C1521 |
| C1522 | |
| C1523 | |
| 25 | C1531 |
| C1532 | |
| C1533 | |
| C1534 | |
| C1551 | |
| C1555 | |
| 26 | C1581 |
| C1582 | |
| 41 | U0100 |
| 42 | U0129 |
| 44 | C1567 |
| 45 | U023A |
| 47 | U0126 |
CLEAR DTCs (USING GTS)
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / EMPS / Trouble Codes.
Clear the DTCs.
Turn the ignition switch off.
Disconnect the GTS from the DLC3.