Home › Brake › PARKING BRAKE › ELECTRIC PARKING BRAKE SYSTEM › 2017.09–2021.02
RM33A0E _54 Brake _065369 PARKING BRAKE _0328504 ELECTRIC PARKING BRAKE SYSTEM J

PARKING BRAKE  ELECTRIC PARKING BRAKE SYSTEM  Message Not Displayed on Multi-information Display When AUTO Function Set to ON/OFF  


DESCRIPTION

When the AUTO function is set to ON/OFF, a message is displayed on the multi-information display in the combination meter assembly.

WIRING DIAGRAM

C381929E04
1.25,0.583 6.344,0.813 5.094,0.229 10 false Skid Control ECU (Brake Actuator Assembly) 1.25,1 5.427,1.208 4.177,0.208 10 false - Multi-information Display Request Signal 1.25,2.5 3.802,2.802 2.552,0.302 10 false Combination Meter Assembly 1.25,2.917 5.49,3.156 4.24,0.24 10 false - Multi-information Display 0.844,4.188 3.25,4.563 2.406,0.375 10 false : CAN Communication Line

CAUTION / NOTICE / HINT

NOTICE:
·

The electric parking brake may still operate up to 20 seconds after the power switch is turned off. Before disconnecting connectors or fuses, turn the power switch off and wait 20 seconds or more.

·

When replacing the skid control ECU (brake actuator assembly), operate the electric parking brake switch (electric parking brake switch assembly), as the parking brake indicator light (red) blinks when the power switch is first turned on (IG).



PROCEDURE

1.CHECK OPERATION OF AUTO FUNCTION
a.

Check that the AUTO function operates when the operating conditions are met.

HINT:

Do not use the multi-information display to determine whether the AUTO function is operating or not.



Result:
Result Proceed to
The AUTO function operates. A
The AUTO function does not operate. B



A

REPLACE COMBINATION METER ASSEMBLY

B

GO TO Electric Parking Brake System AUTO Function Circuit