The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during combination meter assembly removal/installation are shown below.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2. CHANGE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM SETTINGS (for Power Tilt and Power Telescopic Steering Column)
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
for 2AR-FE:
Click hereGeneral>MAINTENANCE>2AR-FE BATTERY>REMOVAL
for A25A-FKS:
Click hereGeneral>MAINTENANCE>A25A-FKS BATTERY>REMOVAL
for 2GR-FKS:
Click hereGeneral>MAINTENANCE>2GR-FKS BATTERY>REMOVAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
55435B
4.REMOVE NO. 1 METER HOOD CLUSTER
55436B
5.REMOVE NO. 2 METER HOOD CLUSTER
55410C
6.REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
for Manual Tilt and Manual Telescopic Steering Column:
Release the tilt and telescopic lever and fully extend and lower the steering column assembly.
Lock the tilt and telescopic lever.
|
Protective Tape |
Apply protective tape to the area shown in the illustration.
|
Protective Tape |
Apply protective tape to the area shown in the illustration.
|
Remove in this Direction |
Disengage the 2 claws and 4 clips to separate the instrument cluster finish panel assembly.
Remove the 2 clips.
|
Place Hand Here |
|
Remove in this Direction |
Disengage the 2 clips as shown in the illustration.
|
Place Hand Here |
|
Remove in this Direction |
Disengage the 2 clips as shown in the illustration.
|
Remove in this Direction |
Disengage the 2 guides as shown in the illustration.
Disconnect the connector to remove the instrument cluster finish panel assembly.
83100
7.REMOVE COMBINATION METER ASSEMBLY
Remove the 3 screws.
|
Remove in this Direction |
Disengage the 2 clips as shown in the illustration.
Disengage the clamp.
Disconnect each connector to remove the combination meter assembly.