Home › Engine / Hybrid System › A25A-FKS (EMISSION CONTROL) › EGR COOLER › 2017.09–2017.12
RM33A0E _51 Engine / Hybrid System _065344 A25A-FKS EMISSION CONTROL _0328567 EGR COOLER A

A25A-FKS EMISSION CONTROL  EGR COOLER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during EGR cooler assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function when Necessary Procedure not Performed Link
Gas leak from exhaust system is repaired Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 1.DRAIN ENGINE COOLANT

Hide 12601B 2.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 3.REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE

Hide 25680 4.REMOVE EGR COOLER ASSEMBLY

a.
A402221C01
2.115,1.167 2.51,1.167 true 0.865,1.031 1.26,1.031 true 0.698,0.948 0.906,1.146 0.208,0.198 10 true *1 2.531,1.083 2.74,1.271 0.208,0.188 10 true *2
*1 Water Hose Connector Sub-assembly
*2 No. 3 Water By-pass Hose


Slide the 2 clips and disconnect the water hose connector sub-assembly and No. 3 water by-pass hose from the EGR cooler assembly.


b.
A402222

Remove the 5 bolts and EGR cooler assembly from the cylinder head sub-assembly and EGR valve assembly.


c.
A402224

Remove the EGR valve gasket from the EGR valve assembly.


d.
A402223

Remove the EGR cooler gasket from the EGR cooler assembly.