The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during exhaust manifold (TWC: Front Catalyst) removal/installation are shown below.
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.
53851M
1.REMOVE FRONT WHEEL OPENING EXTENSION PAD RH
53852K
2.REMOVE FRONT WHEEL OPENING EXTENSION PAD LH
51441
3.REMOVE NO. 1 ENGINE UNDER COVER
58166A
4.REMOVE FRONT FLOOR COVER LH
58165C
5.REMOVE FRONT FLOOR COVER RH
57533B
6.REMOVE FRONT CENTER FLOOR BRACE
57523A
7.REMOVE CENTER FLOOR CROSSMEMBER BRACE
17410
8.REMOVE FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)
To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.
Disengage the wire harness clamp.
Disconnect the air fuel ratio sensor (for sensor 2) connector.
Remove the 2 bolts, 2 nuts and disconnect the front exhaust pipe assembly (TWC: Rear Catalyst) from the exhaust manifold (TWC: Front Catalyst) and center exhaust pipe assembly.
Remove the front exhaust pipe assembly (TWC: Rear Catalyst) from the 2 exhaust pipe supports.
Remove the 2 gaskets from the front exhaust pipe assembly (TWC: Rear Catalyst).
58152A
9.REMOVE FRONT LOWER NO. 1 FLOOR HEAT INSULATOR
10.REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY
55708
11.REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY
53607A
12.REMOVE FRONT CENTER UPPER SUSPENSION BRACE SUB-ASSEMBLY
89467B
13.REMOVE AIR FUEL RATIO SENSOR (for Sensor 1)
14.REMOVE WIRE HARNESS CLAMP BRACKET
Remove the bolt and wire harness clamp bracket.
17167
15.SEPARATE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
Remove the 5 bolts and separate the No. 1 exhaust manifold heat insulator from the exhaust manifold (TWC: Front Catalyst).
58151
16.SEPARATE NO. 1 UPPER FRONT FLOOR HEAT INSULATOR
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
Remove the 2 nuts and separate the No. 1 upper front floor heat insulator from the vehicle body.
17118
17.REMOVE MANIFOLD STAY
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
Remove the bolt, nut and manifold stay from the exhaust manifold (TWC: Front Catalyst) and cylinder block sub-assembly.
17141
18.REMOVE EXHAUST MANIFOLD (TWC: Front Catalyst)
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
Using a 12 mm deep socket wrench, remove the 7 nuts and separate the exhaust manifold (TWC: Front Catalyst) from the cylinder head sub-assembly.
Remove the No. 1 exhaust manifold heat insulator, No. 1 upper front floor heat insulator and exhaust manifold (TWC: Front Catalyst).
Remove the exhaust manifold to head gasket from the cylinder head sub-assembly.
17168
19.REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR
Remove the 6 bolts and No. 2 exhaust manifold heat insulator from the exhaust manifold (TWC: Front Catalyst).