The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during cam timing control motor with EDU assembly removal/installation are shown below.
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
12601B
2.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
47381J
3.REMOVE NO. 2 BRAKE TUBE CLAMP BRACKET
12602C
4.REMOVE NO. 2 ENGINE COVER
13090D
5.REMOVE CAM TIMING CONTROL MOTOR WITH EDU ASSEMBLY
Disconnect the cam timing control motor with EDU assembly connector.
Remove the 3 bolts and cam timing control motor with EDU assembly from the No. 2 timing chain cover assembly.
If the cam timing control motor with EDU assembly has been struck or dropped, replace it.
13090E
6.REMOVE CAM TIMING CONTROL MOTOR O-RING
Remove the cam timing control motor O-ring from the No. 2 timing chain cover assembly.