17650H
1.REMOVE VACUUM SWITCHING VALVE (for Active Control Engine Mount System)
53851M
2.REMOVE FRONT WHEEL OPENING EXTENSION PAD RH
53852K
3.REMOVE FRONT WHEEL OPENING EXTENSION PAD LH
51441
4.REMOVE NO. 1 ENGINE UNDER COVER
5.REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY
12361A
6.REMOVE FRONT ENGINE MOUNTING INSULATOR
Disengage the 4 clamps to separate the radiator hose, vacuum hoses and No. 2 engine wire from the No. 1 radiator bracket.
Remove the bolt and No. 1 radiator bracket from the front engine mounting bracket.
Disengage the 2 clamps to separate the vacuum hoses from the front engine mounting insulator.
Disconnect the vacuum hose from the front engine mounting insulator.
|
Wooden Block Placement Location |
Support the engine assembly with transaxle using a jack and wooden block.
Remove the 4 bolts and front engine mounting bracket.
Remove the 3 nuts and front engine mounting insulator from the front frame assembly.
Remove the nut and stay from the front engine mounting insulator.