Home › Engine / Hybrid System › A25A-FKS (ENGINE CONTROL) › KNOCK SENSOR › 2017.09–2017.12
RM33A0E _51 Engine / Hybrid System _065341 A25A-FKS ENGINE CONTROL _0328601 KNOCK SENSOR A

A25A-FKS ENGINE CONTROL  KNOCK SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 89615 1.INSTALL KNOCK CONTROL SENSOR

HINT:

Perform "Inspection After Repair" after replacing the knock control sensor.

Click hereEngine / Hybrid System>A25A-FKS (ENGINE CONTROL)>SFI SYSTEM (w/ Canister Pump Module)>INITIALIZATION


a.
A402378C01
1.719,2.135 2.031,2.292 0.313,0.156 10 true *a 0.708,3.99 1.021,4.146 0.313,0.156 10 false *b 1.302,2.521 1.615,2.677 0.313,0.156 10 false *c 1.865,2.49 2.177,2.646 0.313,0.156 10 false *d
*a Top
*b Right of Vehicle
*c 15°
*d 5°


Install the knock control sensor to the cylinder block sub-assembly with the bolt so that the knock control sensor installation position is as shown in the illustration.

Torque:
21 N*m (214 kgf*cm, 15 ft.*lbf)

NOTICE:
·

If the knock control sensor has been struck or dropped, replace it.

·

Make sure that the knock control sensor is in the correct position.




b.

Connect the knock control sensor connector.


Hide 3.PERFORM INITIALIZATION

a.

Perform "Inspection After Repair" after replacing the knock control sensor.

Click hereEngine / Hybrid System>A25A-FKS (ENGINE CONTROL)>SFI SYSTEM (w/ Canister Pump Module)>INITIALIZATION