The refreshing seat switch communicates with the air conditioning amplifier assembly via LIN communication.
If the LIN communication system is malfunctioning, the air conditioning amplifier assembly will not operate even if the refreshing seat switch is operated.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B14B5 | Lost Communication with Front Seat Temperature Adjustment Switch LIN | Lost communication with the refreshing seat switch | ·
Refreshing seat switch ·
Air conditioning amplifier assembly ·
Wire harness or connector ·
ECU-IG1 NO. 4 fuse |
Inspect the fuses for circuits related to this system before performing the following procedure.
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
DTC B14B5 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
| *a | Front view of wire harness connector
(to Refreshing Seat Switch) |
Disconnect the K49 refreshing seat switch connector.
Measure the voltage and resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K49-1 (IG) - Body ground | Engine switch on (IG) | 11 to 14 V |
| K49-1 (IG) - Body ground | Engine switch off | Below 1 V |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K49-5 (E) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the K54 air conditioning amplifier assembly connector.
Disconnect the K49 refreshing seat switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| K54-14 (LIN1) - K49-3 (SLIN) | Always | Below 1 Ω |
| K54-14 (LIN1) or K49-3 (SLIN) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Temporarily replace the refreshing seat switch with a new or known good one.
Click hereVehicle Interior>SEAT>SEAT HEATER SWITCH (for Front Side)>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
DTC B14B5 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG