When the sliding roof ECU (sliding roof drive gear assembly) or roof sunshade ECU (sliding roof drive gear assembly) detects a motor malfunction and the sliding roof and roof sunshade operation is stopped, DTC B2341 is stored.
When the sliding roof ECU (sliding roof drive gear assembly) or roof sunshade ECU (sliding roof drive gear assembly) detects a gear position malfunction and the sliding roof and roof sunshade operation is stopped, DTC B2344 is stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B2341 | Sensor (Motor) Failure | Sensor (motor) failure (When the sliding roof ECU (sliding roof drive gear assembly) enters fail-safe mode due to a problem with the motor) | ·
Sliding roof ECU (Sliding roof drive gear assembly) ·
Panoramic moon roof switch (Roof console box sub-assembly) ·
Wire harness or connector |
| B2344 | Position Failure | Position failure (When the sliding roof ECU (sliding roof drive gear assembly) enters fail-safe mode due to a problem with the gear position) | ·
Sliding roof ECU (Sliding roof drive gear assembly) ·
Panoramic moon roof switch (Roof console box sub-assembly) ·
Wire harness or connector |
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B2341 | Sensor (Motor) Failure | Sensor (motor) failure (When the roof sunshade ECU (sliding roof drive gear assembly) enters fail-safe mode due to a problem with the motor) | ·
Roof sunshade ECU (Sliding roof drive gear assembly) ·
Panoramic moon roof switch (Roof console box sub-assembly) ·
Wire harness or connector |
| B2344 | Position Failure | Position failure (When the roof sunshade ECU (sliding roof drive gear assembly) enters fail-safe mode due to a problem with the gear position) | ·
Roof sunshade ECU (Sliding roof drive gear assembly) ·
Panoramic moon roof switch (Roof console box sub-assembly) ·
Wire harness or connector |
If the sliding roof ECU (sliding roof drive gear assembly) or roof sunshade ECU (sliding roof drive gear assembly) is removed and reinstalled or replaced, the sliding roof ECU (sliding roof drive gear assembly) or roof sunshade ECU (sliding roof drive gear assembly) must be initialized.
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>PANORAMIC MOON ROOF SYSTEM>INITIALIZATION
DTCs B2341 and B2344 are stored in the sliding roof ECU (sliding roof drive gear assembly) and roof sunshade ECU (sliding roof drive gear assembly).
Clear the DTCs.
Check for DTCs.
DTCs B2341 and B2344 are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Check the parts from which this DTC has been output.
| Result | Proceed to |
|---|---|
| DTC output from sliding roof ECU (sliding roof drive gear assembly) | A |
| DTC output from roof sunshade ECU (sliding roof drive gear assembly) | B |
A
B
Check the sliding roof auto operation function.
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>PANORAMIC MOON ROOF SYSTEM>OPERATION CHECK
Auto operation function operates normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Clear the DTCs.
Check for DTCs.
DTCs B2341 and B2344 are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF HOUSING (for Panoramic Moon Roof)>REMOVAL
Check that the sliding roof ECU (sliding roof drive gear assembly) can be initialized.
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>PANORAMIC MOON ROOF SYSTEM>INITIALIZATION
Sliding roof ECU (sliding roof drive gear assembly) can be initialized.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Clear the DTCs.
Check for DTCs.
DTCs B2341 and B2344 are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF HOUSING (for Panoramic Moon Roof)>REMOVAL
Disconnect the q1 sliding roof ECU (sliding roof drive gear assembly) connector.
Disconnect the V14 panoramic moon roof switch (roof console box sub-assembly) connector.
Disconnect the q2 roof sunshade ECU (sliding roof drive gear assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| q1-8 (ROOF CLOSE) - V14-4 (CLS) | Always | Below 1 Ω |
| q1-8 (ROOF CLOSE) or V14-4 (CLS) - Body ground | Always | 10 kΩ or higher |
| q1-10 (ROOF OPEN) - V14-5 (OPN) | Always | Below 1 Ω |
| q1-10 (ROOF OPEN) or V14-5 (OPN) - Body ground | Always | 10 kΩ or higher |
| q1-4 (VENT) - V14-19 (B) | Always | Below 1 Ω |
| q1-4 (VENT) or V14-19 (B) - Body ground | Always | 10 kΩ or higher |
| q1-5 (SHADE OPEN) - V14-3 (UP) | Always | Below 1 Ω |
| q1-5 (SHADE OPEN) or V14-3 (UP) - Body ground | Always | 10 kΩ or higher |
| q1-9 (SHADE CLOSE) - V14-18 (DOWN) | Always | Below 1 Ω |
| q1-9 (SHADE CLOSE) or V14-18 (DOWN) - Body ground | Always | 10 kΩ or higher |
| q1-2 (E) - Body ground | Always | Below 1 Ω |
| V14-15 (GND) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the panoramic moon roof switch (roof console box sub-assembly).
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF SWITCH ASSEMBLY>REMOVAL
Inspect the panoramic moon roof switch (roof console box sub-assembly).
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF SWITCH ASSEMBLY>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF HOUSING (for Panoramic Moon Roof)>REMOVAL
NG
Check the roof sunshade auto operation function.
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>PANORAMIC MOON ROOF SYSTEM>OPERATION CHECK
Auto operation function operates normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Clear the DTCs.
Check for DTCs.
DTCs B2341 and B2344 are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF HOUSING (for Panoramic Moon Roof)>REMOVAL
Check that the roof sunshade ECU (sliding roof drive gear assembly) can be initialized.
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>PANORAMIC MOON ROOF SYSTEM>INITIALIZATION
Roof sunshade ECU (sliding roof drive gear assembly) can be initialized.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Clear the DTCs.
Check for DTCs.
DTCs B2341 and B2344 are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF HOUSING (for Panoramic Moon Roof)>REMOVAL
Disconnect the q2 roof sunshade ECU (sliding roof drive gear assembly) connector.
Disconnect the V14 panoramic moon roof switch (roof console box sub-assembly) connector.
Disconnect the q1 sliding roof ECU (sliding roof drive gear assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| q2-8 (ROOF CLOSE) - V14-4 (CLS) | Always | Below 1 Ω |
| q2-8 (ROOF CLOSE) or V14-4 (CLS) - Body ground | Always | 10 kΩ or higher |
| q2-10 (ROOF OPEN) - V14-5 (OPN) | Always | Below 1 Ω |
| q2-10 (ROOF OPEN) or V14-5 (OPN) - Body ground | Always | 10 kΩ or higher |
| q2-4 (VENT) - V14-19 (B) | Always | Below 1 Ω |
| q2-4 (VENT) or V14-19 (B) - Body ground | Always | 10 kΩ or higher |
| q2-5 (SHADE OPEN) - V14-3 (UP) | Always | Below 1 Ω |
| q2-5 (SHADE OPEN) or V14-3 (UP) - Body ground | Always | 10 kΩ or higher |
| q2-9 (SHADE CLOSE) - V14-18 (DOWN) | Always | Below 1 Ω |
| q2-9 (SHADE CLOSE) or V14-18 (DOWN) - Body ground | Always | 10 kΩ or higher |
| q2-2 (E) - Body ground | Always | Below 1 Ω |
| V14-15 (GND) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the panoramic moon roof switch (roof console box sub-assembly).
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF SWITCH ASSEMBLY>REMOVAL
Inspect the panoramic moon roof switch (roof console box sub-assembly).
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF SWITCH ASSEMBLY>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF HOUSING (for Panoramic Moon Roof)>REMOVAL
NG