Home › Engine / Hybrid System › 2GR-FKS (EMISSION CONTROL) › PURGE VALVE
RM33A0E _51 Engine / Hybrid System _065335 2GR-FKS EMISSION CONTROL _0328621 PURGE VALVE A

2GR-FKS EMISSION CONTROL  PURGE VALVE  INSTALLATION  


PROCEDURE

Hide 25860 1.INSTALL PURGE VALVE (PURGE VSV)

a.
A412395C01
0.615,0.354 0.781,0.354 0.781,0.354 0.979,0.625 true 1.594,1.458 1.594,0.948 true 0.448,0.271 0.646,0.458 0.198,0.188 10 true *1 1.521,1.469 1.729,1.656 0.208,0.188 10 true *2 0.979,0.656 1.167,0.844 0.188,0.188 10 true *a 3.167,1.094 3.385,1.281 0.219,0.188 10 true *b 2.583,0.156 2.792,0.333 0.208,0.177 10 false *c 2.854,0.396 3.104,0.583 0.25,0.188 10 false *d 2.125,0.156 2.313,0.344 0.188,0.188 10 true *a
*1 No. 1 Fuel Vapor Feed Hose
*2 Fuel Vapor Feed Hose
*a View A
*b RH Side
*c Front
*d 120°


Install the purge valve (purge VSV) to the intake air surge tank assembly with the bolt.

Torque:
21 N*m (214 kgf*cm, 15 ft.*lbf)


b.

Connect the No. 1 fuel vapor feed hose to the purge valve (purge VSV).


c.

Connect the fuel vapor feed hose to the purge valve (purge VSV) and slide the clip to secure it.

HINT:

Engage the clip within the area shown in the illustration.



d.

Connect the purge valve (purge VSV) connector.


Hide 11209 2.INSTALL V-BANK COVER SUB-ASSEMBLY