Home › Engine / Hybrid System › 2AR-FE (INTAKE / EXHAUST) › INTAKE AIR CONTROL VALVE ACTUATOR (for TCV) › 2017.09–2021.02
RM33A0E _51 Engine / Hybrid System _065327 2AR-FE INTAKE / EXHAUST _0328638 INTAKE AIR CONTROL VALVE ACTUATOR(for TCV) A

2AR-FE INTAKE / EXHAUST  INTAKE AIR CONTROL VALVE ACTUATOR(for TCV)  INSTALLATION  


PROCEDURE

Hide 17335 1.INSTALL INTAKE AIR CONTROL VALVE ACTUATOR (for TCV)

NOTICE:
·
A203084

Make sure that foreign matter, such as water, oil, sand or iron particles, does not enter the gear chamber or intake air control valve actuator (for TCV) at the locations marked by the circles in the illustration.

·
A197294

Do not loosen or remove the bolt and 2 nuts shown in the illustration.



a.
A292929C02
0.073,0.052 0.385,0.208 0.313,0.156 10 *a
*a Tumble Control Valves (TCV) Closed


Check that the 4 tumble control valves (TCV) are closed.

HINT:

If the 4 tumble control valves (TCV) are not closed, close them by hand.



b.
A212080C04
1.625,2.542 1.625,2.208 false 0.135,0.156 0.396,0.417 0.26,0.26 10 false *a 1.563,2.583 1.875,2.781 0.313,0.198 10 false *b
*a Tumble Control Valves (TCV) Closed
*b Stopper


Check that the gear of the 4 tumble control valves (TCV) is in the position shown in the illustration.

HINT:

Turn the gear clockwise until it contacts the stopper.



c.

Install a new gasket to the intake air control valve actuator (for TCV).


d.

Install the intake air control valve actuator (for TCV) to the intake manifold with the 2 bolts.

Torque:
6.0 N*m (61 kgf*cm, 53 in.*lbf)

NOTICE:
·

If excessive rotational force is applied to the gear of the 4 tumble control valves (TCV), the 4 tumble control valves (TCV) and intake air control valve actuator (for TCV) may be damaged.

·

After installing the intake air control valve actuator (for TCV), make sure that the 4 tumble control valves (TCV) are not protruding. If the 4 tumble control valves (TCV) are protruding, remove and reinstall the intake air control valve actuator (for TCV).