The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the engine oil level sensor removal/installation are shown below.
*1: When the ECM is replaced with a new one, reset memory is unnecessary.
| *a | An Object Exceeding Weight Limit of Engine Lifter |
The engine assembly with transaxle is very heavy. Be sure to follow the procedure described in the repair manual, or the engine lifter may suddenly drop or the engine assembly with transaxle may fall off the engine lifter.
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
1.INSTALL ENGINE ASSEMBLY TO ENGINE STAND
12102A
2.REMOVE NO. 2 OIL PAN SUB-ASSEMBLY
15104
3.REMOVE OIL STRAINER SUB-ASSEMBLY
89491
4.REMOVE ENGINE OIL LEVEL SENSOR
Remove the clip from the engine oil level sensor.
Remove the 2 nuts and engine oil level sensor from the oil pan sub-assembly.